Goblin mini resistance

[OhmzRaw]

I have a goblin mini running a 5 wrap 2mm ID reading at 0.68 ohm. The resistance changes at massive increases all the time. I put the tank on my Evic before wicking and it read 0.38 ohm then I just played with the wire and it shot up to 0.47ohm and then I wicked it and it said 0.78 ohm and now it's reading 0.68 ohm. What is wrong with it? Is my build crappy or is it the tank? Or the device? Tried it on my Evic VT and VTC.

 

[msrfrog]

I have a goblin mini running a 5 wrap 2mm ID reading at 0.68 ohm. The resistance changes at massive increases all the time. I put the tank on my Evic before wicking and it read 0.38 ohm then I just played with the wire and it shot up to 0.47ohm and then I wicked it and it said 0.78 ohm and now it's reading 0.68 ohm. What is wrong with it? Is my build crappy or is it the tank? Or the device? Tried it on my Evic VT and VTC.

I found that happens when the coil wire is not tight enough in the post. Which would cause the fluctuations in the resistance.

Sent from my A0001 using Tapatalk

 

[xcrazydx]

I have a goblin mini running a 5 wrap 2mm ID reading at 0.68 ohm. The resistance changes at massive increases all the time. I put the tank on my Evic before wicking and it read 0.38 ohm then I just played with the wire and it shot up to 0.47ohm and then I wicked it and it said 0.78 ohm and now it's reading 0.68 ohm. What is wrong with it? Is my build crappy or is it the tank? Or the device? Tried it on my Evic VT and VTC.

Crappy build, loose contacts etc.

 

[OhmzRaw]

Crappy build, loose contacts etc.

Yes I most certainly think it's a loose contact.

 

[93gc40]

Loose connection. Either at the coil or at the 510 or one of the posts. Could also be, the coil is touching the walls of the atty or something they shouldn't.