Goliath V2 O Ring Placement

[Joelolly]

Hey guys. First time poster here. I've goofed... I just bought a Goliath V2 and completely disassembled it. I removed the O rings to soak the device in rubbing alcohol to remove any machine oil. No, being the genius that I am, I can't remember where two o rings go. There are three total black o rings: one small, one medium, one large. I know the small one goes on the top of the chimney, but I can't figure out if the medium one goes on the base or the connector. I've put it back together the way I think it goes, but I'm getting some leaking from where the juice flow control meets the connector. Do any of you vaping guru's have an idea where these O rings go? Again, I know one goes on the base and the other on the connector, but I'm not sure which goes where. Thanks in advance for any advice/help.

 

[sacullen]

Did you try switching those two orings around? Seems like the logical next step.

 

[Joelolly]

Yep. Trying one way seemed like the fit was way too snug. Maybe it's supposed to be though?

 

[zed888]

The base on mine is snug as hell. I've had to use a screwdriver through the air holes to unscrew it.