Ok so I got my DCA today after waiting a week or so for them to become available. Shipping took about 4 days. I had ordered the polished DCA with the extra tops and one of GSV's 3 ohm 306's (according to site was the last one they had and I wanted to make certain I had a 306 that was definitely going to fit). Well I got a note instead stating they ran out of the 3 ohm 306's so they sent me 2, free flow 1.5 ohm attys free of charge. Now that's customer service! So my first impression....man this looks cheap. Kinda reminds me of the shiny silver plastic on kids toys. But after tinkering around with it I see it's very well made and sturdy. Light but seems like it would be very durable. Looks quite nice on my satin silver provari. Decided to use one of their 306's first. Slid right into the upper, snugged it down and bam, works like a charm. Didn't take long to notice their 306's don't compare to my Cisco 306's so I used the small upper and put on my Cisco atty. Fit snug just like its suppose to. I was surprised that the DCA set up seems to improve my flavor just a tad while dripping. Adjustments with the center pin are a cinch. Loosen the top and tighten the bottom to increase airflow. Overall I'm very pleased with this set up. Seems ideal for dripping and will be my go to dripping set up. I have other 306's with drip shields but this one is certainly going to take them over.
