GP-SSR Available now!
- Thread starter dirt2suck
- Start date
- th_trl_thread_readers 0
- Status
We just put the XL tubes in.
These are the tubes only, and the SSR and XL SSR will be a couple weeks.
We are trying to get feedback before manufacturing quantity.
No more inventory problems should occur after next release.
These are the tubes only, and the SSR and XL SSR will be a couple weeks.
We are trying to get feedback before manufacturing quantity.
No more inventory problems should occur after next release.
Rob,
Do you have specific people giving you feedback on the GP-SSR?.
Can anyone give feedback on the GP-SSR?
What is the best way to submit feedback on the GP-SSR?
Could you start a thread for feedback on the GP-SSR?
Thank you.
PK
Still waiting on mine, so I haven't gotten to get a close look yet. You mention in the instructions that the silicon ring is pushed down into the cap, Is this required? I normally end up pulling that out of my CE2's and tossing them. Will it leak like crazy with out it?
I experimented a lil' bit. I put the silicone ring as it (not upside down) but I do not push the cap back on all the way down. As long as the O ring on the cap is in the tube, it will not leak. I tried it upside down. It will not come off. I lifted it up by the cap and it will hold the weight of my eGo without coming loose. No wicking issue. Just another method to share.
The silicone will just keep it from leaking faster.
Anything that has liquid in it and is not sealed, will eventually leak when upside down.
Just might take a little longer if there is the silicone ring.
Anything that has liquid in it and is not sealed, will eventually leak when upside down.
Just might take a little longer if there is the silicone ring.
It can hold 5-6ml easily
The only problem we see is that with CE2's 5-6ml is about the breaking point until you must clean and dry burn.
I personally dont take it past 5ml....which is a fill and a half on the reg.
The only problem we see is that with CE2's 5-6ml is about the breaking point until you must clean and dry burn.
I personally dont take it past 5ml....which is a fill and a half on the reg.
You need to rinse the CE2 under water, dry it up with paper towel,
then put it on a battery and run it dry.
Let it glow for a few seconds and do another dry burn for 2-3 seconds.
Make sure all the coils are glowing, may take a few dry burns.
Then be gentle and blow or brush the powder off (if any)
then put it on a battery and run it dry.
Let it glow for a few seconds and do another dry burn for 2-3 seconds.
Make sure all the coils are glowing, may take a few dry burns.
Then be gentle and blow or brush the powder off (if any)
When you say tubes, do you mean literally just the tubes, or are all the bits there aside from the atomizer?
I guess I must be well challenged because I don't know were to look on your site that shows just the tubes only. Can anyone help and steer me on where to look.
The XL tubes are in the drop down window for the GP-SSR. Clicking on this link will take you there.
The GP-SSR is also listed under the Accessories tab.
If the GP-SSR or parts for the GP-SSR do not show up in the drop down window that means the item is out of stock.
Last edited:
PZK and BigBopper, my to new assistants...thanks!
Yes, XL tubes only for $8.99 or Reg tubes only $6.99
The CE2 orings 2/$.99
Bottom and top delrin will also be available, along with the delrin orings also.
Yes, XL tubes only for $8.99 or Reg tubes only $6.99
The CE2 orings 2/$.99
Bottom and top delrin will also be available, along with the delrin orings also.
Thanks All(Bri/PZK and Dirt) So I did order the XL Tank. So when you get the rest of the Supplies in including will the Reg Tubes/CE2 and derlin orings/ Delrin top/bottom all be on the same page. I will need to get those rings and another GP-SSR Complete Tank?
Thanks Rob
Thanks Rob
andel,
Best to do is get a full reg setup next.
Then just switch tubes when you need to.
Best to do is get a full reg setup next.
Then just switch tubes when you need to.
Yeah Rob you are right, thats what I am going to do. I would like to get some extra O rings though just incase I lose one. Thanks, I really like this Mod, works great on my Darwin. Thanks for bring it to us.
I think I saw you post that you'll have more in about two weeks or so. Is that correct?
- Status
