Just received my Vision Grande today. Filled it about halfway with DK Tab and screwed it on to my LT. Less than half an hour after using it, it starts leaking like a .... out the battery end. Did I do something wrong? Help!!!!!
Grande leaking! Help!!!
- Thread starter Room112
- Start date
- th_trl_thread_readers 0
- Status
With the DCT, mine will leak if, after filling, I slip the cap on without pulling the carto down to let air escape. If I don't do this, pushing the cap in creates positive pressure which forces juice out the bottom.
I've never used a Vision grande though, so I dunno if that's the problem.
I've never used a Vision grande though, so I dunno if that's the problem.
If its leaking out the bottom that makes me think of two different things. The connector (the actual 510 threading part) or the base of the tube.
If its the connector its one of two things:
1) the seal over the cup at the top where the wick is needs to be seated correctly. It may have gotten lifted up a bit when you were putting juice in
2) the seal on the bottom where the connecter is may not have been installed correctly.
Chances are its number 1
If its the connector its one of two things:
1) the seal over the cup at the top where the wick is needs to be seated correctly. It may have gotten lifted up a bit when you were putting juice in
2) the seal on the bottom where the connecter is may not have been installed correctly.
Chances are its number 1
zer0ith nailed it dead-on;
All it takes is 1mm off the cup and out it goes.
Sensible things those Grande.
All it takes is 1mm off the cup and out it goes.
Sensible things those Grande.
The white seal needs to be pushed completely down onto the cup and needs to be aligned with wicks. There are 4 tiny slits(insert joke here) underneath the white seal that need to be aligned with the wicks. This makes pushing down a bit easier.
I see the markings on the bottom of which you speak but it's tough trying to see through the tank to align the stopper. I'll keep trying though! Thanks for all the tips!
With mine the tiny fill hole was right in the middle of the two wicks on one side. Hope that helps a bit
- Status
Similar threads
