I don't do sub-ohms either...I never had to change any of the fuses on my Gus's. I know your gona love that new lord!
GUS Mods Upgrade
- Thread starter aiolos
- Start date
- th_trl_thread_readers 0
- Status
I don't do sub-ohms either...I never had to change any of the fuses on my Gus's. I know your gona love that new lord!
Just a heads up...
Is that what I think it is?!!!!
That looks like a tri-coil tank system!
More pictures please!
Last edited:
More on The GUS-Estia!
Basic Specs:
1. Tri-coil setup by choosing two level position
2. Posts with holes for trapping the wires (0.50mm)
3. Philips Screws on the posts
4. Air-channels under each coil
5. Air-flow Control (AFC)
6. juice Control
7. Outer Diameter (OD): 22mm => 25mm
8. Height: 45mm (without driptip)
9. juice Capacity: 2.5ml => 5ml
10. Base M20/1 threaded, thus can be hybridized on the GUS and *similar mods.
Basic Specs:
1. Tri-coil setup by choosing two level position
2. Posts with holes for trapping the wires (0.50mm)
3. Philips Screws on the posts
4. Air-channels under each coil
5. Air-flow Control (AFC)
6. juice Control
7. Outer Diameter (OD): 22mm => 25mm
8. Height: 45mm (without driptip)
9. juice Capacity: 2.5ml => 5ml
10. Base M20/1 threaded, thus can be hybridized on the GUS and *similar mods.
Fell in Love all over Again
More on it here: http://www.e-cigarette-forum.com/fo...rd-telescopic-mod-pictorial.html#post12214503
More on it here: http://www.e-cigarette-forum.com/fo...rd-telescopic-mod-pictorial.html#post12214503
New Drip-tips by GUS !
Image shared thru Gusmod Facebook page
thanks for the pic Q, Im not on FB - does he make them without the dimples. ACTUALLY I could go for one engraved all over like the Lord PV - short with flat top - large bore on both ends
Unfortunately No, D
Those 'dimples' are the trademark of Gus. Which is why it's there in the mods (locking ring) as well. Mines are on the way, I'll let you know how it 'feels' at hand.That's a gr8 idea ~ of getting one of the drip-tips bear the same engravings as the LORD. Wow, why didn't I think of it b'fore! I'm hitting Gus right now requesting one to be made. I'll update you on it D.
Heads-Up, D: Gus accepted, yay! A LORD drip-tip is being made and coming my way... Oh boy!
With 'grid pattern' YES, but I'm not sure if it'd be w/out the 'dimples'. In any case I'm fine with the dimples.
WELL - do you have one coming my way too buddy? I better get one also before anyone else. ehehehhe
D, you have his email ID, right? Contact him asap. Mine is going for engraving right now as we write.
- Status
Similar threads
- Locked
