You should check oyut the Ressurector Cartomizers from Crystal Clear Vaping. They are 1.7ohm LR and hold 2 ml of juice. They are incredible and produce tons of vapor. They also sell the boges if you like them. They give free shipping which is nice and also incluyde a free syringe with all carto purchases. And if you get a 15-pack of cartos you get a free syringe AND a freedrip tip.
I HIGHLY recommend you use a syringe to fill your cartos. It is the easiest and most efficient way to fill them. Ive used all three methods and this is by far the best. Especially if your using big cartos like the Ressurectors or Dual Coil Megas. If you just drip into them it takes a LONG time for the juice to settle, and if you dont wait long enough you could ruin the cartomizer. Like other people said, the first fill is very important and a syringe will ensure it is done correctly.
I originally posted this on another thread where someone asked how to fill a Ressurector, but this is really for filling all cartomizers. Just instead of putting 2 ml in a syringe that the Ressurectors hold, you will put the amount of whatever carto you are using holds. If you dont know how much the ones your using hold then just fill slowly and you will see the juice come to the top of the filler. Once the top begins to become "slushy" it is filled.
Heres my copy and paste.
How to fill a cartomizer with a syringe:
"All you have to do is take the dropper part of the bottle off your juice and fill your syringe with 2ml for a new carto. Take the rubber tip off the carto and carefully insert the needle down the side pushing against the metal. DO NOT go thru the filler because it will move it and you could potentially break a connection and your carto. Slide the needle down the side and go all the way to the bottom. Then slowly start dispensing some juice. Dont dispense it all bc then it won't be evenly distributed. Put alittle in, then take it out and insert the needle in a different spot. I normally do it in 3 spots (in a triangle) I found it distributes the best, but you could just do it in 2, on opposite sides. Make sure the needle is at the bOttom bc then you will not have to wait at all for it to settle. Disperse slowly and you will begin to see the toP of the filler become slushy. It is full then, don't put more. If its a new carto is will def hold 2ml, if your refilling it won't take a lot so pay attention and once it gets alittle slushy stop. While your filling hold a napkin or something under the carto bc if you do it too fast a few drops will come out the battery end. If that happens its only bc you did it too fast and the poly fill didn't absorb quick enough.( that happens to me bc I am impatient and fill it in about 10 sec, so I just hold a paper towel or napkin underneath.) wipe up the drops and put the rubber cap back on the carto. Then put the carto between your hands and rub back and forth spinning the carto quickly. This will insure the liquid is evenly distributed in case you put too much on one side from the syringe.
Now you have a perfectly filled ressurector that is ready to be used right away!"
I know it seems alittle intimidating, but it really is very easy to do, even as a new vaper. Doing this will ensure you never singe a carto wick bc it was underfilled, and you dont have to wait along time for the juice to settle down since your pushing the needle all the way to the bottom and filling from there. This wil also ensure you get a LONG life out of most of your cartos. Ive been using 1 Ressurector for over 4 weeks and its still going strong.
Goodluck with everything and I hope your enjoying vaping!!!
. Thanks everyone for your help! I'll let you know how it goes!
