I recently received a Hana dna 30 clone. I acquired it by trading an AR mech mod for it. I am thoroughly impressed. The clone can sub ohm down to .3 I had to test it. It has a volt meter under the ohms and it's accurate. Well it's accurate to the screw on voltage readers. The overall design is very nice. Buttons click smooth and the internals are very clean. It holds 1 18650 and I chose to use a Panasonic. The packaging was horrible. The mod overall works very well and stays true to burning down to .3 ohms. Te overall quality in my opinion is very good. It feels nice in the hand and the buttons click smooth. The only problem I have had is that it will not run a kayfun lower than 1.3 I would say if you come across one buy it if the price is right.
Sent from my iPhone using Tapatalk






Sent from my iPhone using Tapatalk
Last edited: