HCigar VT Inbox (VTinbox) - evolv VT75
- Thread starter Ramsay Bolton
- Start date
- th_trl_thread_readers 0
- Status
Loving this setup.
Sent from my SAMSUNG-SM-N910A using Tapatalk
Sent from my SAMSUNG-SM-N910A using Tapatalk
Nice that the Wasp is, it has gone into the spares box, being replaced by the Armor 1.0. Quite flavorful and it doesn't whistle!
28g fused Clapton.
Dem brown o-rings!
What it the material on the single coil reducer?
Mine is 0 as well, it should really be measured instead of just putting in a number. Use the tool from SmokeFreeMods or similar.
If you have an atty, that you know the resistance of and can be shorted out, you can use that and subtract the resistance, or you can try just shorting out the 510 with a peice of copper.
I use a little copper plug that is 510 threaded, a guy on the evolv forums used to sell them
I use a little copper plug that is 510 threaded, a guy on the evolv forums used to sell them
I've seen that done with old carto's as well. I'll have to dig around in my junk box.
My cheap thrill would be for an "Inbox" with dna60, 20700 battery, and a bit larger bottle (use that extra couple mm).
Must-have would be to upgrade the magnets. I haven't had issues squonking, but the mod is light enough to be lanyard friendly except for the darn doors popping off if the mod is even lightly tapped.
Must-have would be to upgrade the magnets. I haven't had issues squonking, but the mod is light enough to be lanyard friendly except for the darn doors popping off if the mod is even lightly tapped.
Fixed my doors with flat surface and sand paper. Took the warp out made alot of difference once they sit flat.
Sent from my SAMSUNG-SM-N910A using Tapatalk
The. Sanyo 20700b are stellar for me, at my standard 25w with txp kanthal 26 awg. I got 28-29ml on one pair of them, 32 on a second (using an ijoy captain pd270). I'll do my second set of runs with both pairs starting tomorrow. (I use it during the work week, office. I prefer a single battery lanyard setup on weekends.)
The 20700b is an honest 4000 mAh, though only good for 15 - 16 amps.
The 20700b is an honest 4000 mAh, though only good for 15 - 16 amps.
I'm having problems with my inbox.
The 510 pin won't spring out and atomizers that didn't need tightening all the way down won't fire any more.
Usually if I take off a RDA the pin decompresses back but either mines stuck or the 510 pin isn't spring loaded.
I may have to take apart and see what's keeping 510 pin compressed.
The 510 pin won't spring out and atomizers that didn't need tightening all the way down won't fire any more.
Usually if I take off a RDA the pin decompresses back but either mines stuck or the 510 pin isn't spring loaded.
I may have to take apart and see what's keeping 510 pin compressed.
I let inbox sit without a RDA on it overnight but it only decompressed by a mm if even that.
The inbox may need some type of a 510 upgrade or an adjustable type of 510 pin.
Unfortunately BF atomizers don't all have adjustable 510 pins and when they do the resistance can start jumping around.
Tearing down the inbox requires soldering and I don't think pulling 510 assembly would be any help since it's one unit.
Maybe there's a 510 that will fit in it??
Unfortunately I doubt it, most of the good aftermarket ones I've used are thread-in, like the varitube or evolv ones, but you can check the FDV or modcrate bf ones, those may work but you'll need to make two holes at the top of the frame to put the screws in.
- Status
