New to the vivi nova mini. Came in a pack with 2 spare coils. One already fitted worked fine tried another to try different flavour nothing. Then tried the other spare still nothing. Only the original works (what came fitted in the centre pipe. Could it be just a dodgey batch of coils. Or something more sinister as my centre pipe sits slightly off centre and has a small dent on the outside near the coil thread and could it be its been damaged with the coil what came already in and has bent to not heat another coil if its inserted?
Heeeellllllppppp
- Thread starter Livaz1
- Start date
- th_trl_thread_readers 0
- Status
My first thought was that you didn't have the replacement heads screwed in tight, but sounds like you put the original one in and got it to work. You could check them with a meter to see if they're bad or you could screw the replacement head directly into your PV and see if it fires. If they're DOA you should contact whoever you got them from and ask for a replacement. Hope that helps.
Does the mini come with all the same ohm coils? My regular size one came with 1.8, 2.2 and 2.5ohm coils.
I am not sure about the mini nova but I have a T3 that the bottom pin gets pushed in to far and will no contact the battery post when screwed on the battery. This causes no fire or power to the coil. I have to grasp the pine with needle nose pliers and pull it out just a little bit. I have to do this often because I have a bad habit of tightening my atty down too much
i found some of the heads need to be tight! and just screwing the cap back on will mess with them if they are not. if its a knock off nova the heads may be out of spec just a hair and not touching the post inside the center tube also.
- Status
Similar threads
