Help! Just got my vision stone 2 and grandes - first time user!

[madsen6466]

So the grande is just a fill and go right? Do I need to prep the stone at all???

 

[burns_erin]

Grande yes, is fill and go. Make sure if you adjust the inner plug it is either attached to a battery, or the battery connection is pressed firmly against a flat surface.

Stone: Make absolutely dead certain the wick slits are lined up with the wicks. Also, make sure the bottom is firmly screwed on. The are kind of hand assembled with not as much care to detail BECAUSE they are designed for changeability, if that makes sense. So don't fill it before checking the bottom cap. Also, when you screw on the top cap make sure the wick slits stay lined up with the wicks. You may need to lubricate the top cap and the seal before screwing to make sure it doesn't shift too much.

And read the stone thread. The whole stone thread, lol.

 

[otrpu]

Ya, I found the guy that screws on the bottom caps is trying to get a raise by doing a greater quantity and only screwing the caps on half way. Needs to be screwed all the way or it leaks. JMHO

Cheers,
otrpu

 

[frequentj]

These do have a little bit of a break in time before the coil gets good and going, so you'll get better performance after you vape it a bit.

 

[Briar]

Right, break-in time does matter with these. I just started my second Grande, and for first maybe quarter tank it was nowhere near as good as it is now. So be a little patient - different units might take a bit longer, or a bit shorter time - and don't judge it by first few vapes. Other than that, Grande is pretty fiddle-less.

You might have to lift the plug a little if you are using a really really thick VG juice, I didn't on my first one, but did on my second one. So listen to Erin and keep it on the batt if you do that - here speaks the voice of experience!

 

[burns_erin]

On the Grande, you might want to go through this thread:

http://www.e-cigarette-forum.com/fo...ion-grande-5ml-question-pertains-leaking.html