- Status
does a nemesis have an adjustable top post that screws from the inside? I read another post where a mech mod had a rsst stuck on it. Turns out the center post was binding and all the op needed to do was loosen the top post.
yes it does have one but it didnt help
eGo-v knock off, eVic, ProVari mini, Smoktech Pyrex DCT, RY4 Kustom
Dang. Pretty far from me. So let me get this right. You unscrewed the top cap from the tube and then unscrewed the center post that touches the battery?
Yea, and it ain't the mod that scares me
Watched a gut at work fighting like crazy to get his Lift truck forks out from under a collapsed pallet.
Stopped him, got 3 small boards to sit the pallet on paralleling the forks. Backed right out.
Some times simpler is smarter.
Simpler is smarter, but when your sitting on top of a forklift anything that involves getting off your rear (like getting stickers to place underneath a load to get your forks out) jumps in perceived complexity tenfold.
I probably would have just wedged the pallet against something and scraped it off my forks. No need to get up
The picture, or the typed out list of products owned by the OP? Which his damaged nemesis is oddly absent from, BTW. I guess a smoktek dct and a knockoff ego are more worth typing out every post than a Nemesis and a Kayfun.
Last edited:
well I was being lazy and havent got a chance to update my signature
I have Nemesis Eric's Amber, Poldiac, GP Paps LUX 2.5 and eVic
and Kayfun ES 3.1, Kayfun Lite and Ithaka
bty MAD PROPS to Vaperev. They never gave up and got the job done and even wanted to brush out the scratches for free.
I have Nemesis Eric's Amber, Poldiac, GP Paps LUX 2.5 and eVic
and Kayfun ES 3.1, Kayfun Lite and Ithaka
bty MAD PROPS to Vaperev. They never gave up and got the job done and even wanted to brush out the scratches for free.
In the freezer for 20 minutes, then use a pair of plyers/grippers on the nemesis topcap end... You should be able to grip without getting the airflow control ring... And a pair of rubber gloves for the kayfun.
Has worked every time for me.
Has worked every time for me.
sub ohm vaping caused the 510 threads to get little twisted.
vaperev asked me if they can destroy the nemesis top cap's thread and i told them go ahead if that will help.
they ended up selling me stealth cap with discount lol
eGo-v knock off, eVic, ProVari mini, Smoktech Pyrex DCT, RY4 Kustom
The nemesis top cap has the stupid air flow ring that's on with Orings so it keeps spinning and spinning. That's the issue, it's hard to grip I had an Ithaka get stuck too. I also had to use pliers and also unfortunately put a couple small scuffs in the nemesis. Be careful with the nemesis, that is a design flaw for those very possible situations.
indeed. thats the worst part if nemesis
eGo-v knock off, eVic, ProVari mini, Smoktech Pyrex DCT, RY4 Kustom
Remove Top Cap
Loosen Center Contact Pin to release pressure on Kayfun post
Remove Kayfun
Simple works best
What he said. ^^^
- Status
Similar threads
- Locked
