just got a nice,clean,new kangertech pro tank 2 (clear) today and i love it.. except for the fact that it spits at me every ten or so hits... ive tried blowing it clean a few times,which works,for about 5 mins then it starts spitting again. im using 2.2 ohm coil with a 650mah 3.7v battery from a starter kit. someone suggested more cotton in the coil but this is one of those quick change coils. im not sure what to do here...
help! my NEW pt2 spitting and wont stop...
- Thread starter BuzzKillBob
- Start date
- th_trl_thread_readers 0
- Status
I assume you did not but extra coil heads then?
Check that everything is properly snugged. Bottom coil tanks depend on vacuum(no air leaking in) to function without flooding.
Avoid blocking the base of the tank with your hand while vaping.
Avoid Hard Draws.
Both of these things increase tube vacuum and draw more fluid through the wick.
When you want more take longer, not stronger draws.
Check that everything is properly snugged. Bottom coil tanks depend on vacuum(no air leaking in) to function without flooding.
Avoid blocking the base of the tank with your hand while vaping.
Avoid Hard Draws.
Both of these things increase tube vacuum and draw more fluid through the wick.
When you want more take longer, not stronger draws.
i did buy new coils,plus the box came with a spare from factory... i put the new coil in as i thought that may be the issue but its doing the same thing... i do not draw hard on any tank i have,as i have experienced flooding with my t3s before...
are you tightening the coils when you screw them in? make sure the rubber grommet stays down on the wicks too.
Take it apart and clean the areas where the glass connects if any juice is there the tank cant/won't seal properly.
yes,and yes... i make sure they are snug,not over tight,and i double check the rubber piece by wick is on securely
I'll assume it's flooding and your getting liquid in mouth?
Make sure all pieces are tightly screwed together, also make sure coil upper grommet is in place, u can also try adding an additional flavor wick, but this may cause dry hits. You also do not need to tilt and twirl this type of clearo.
most important don't use as a drumstick to your favorite song, this is very bad and has dire consequences.
Make sure all pieces are tightly screwed together, also make sure coil upper grommet is in place, u can also try adding an additional flavor wick, but this may cause dry hits. You also do not need to tilt and twirl this type of clearo.
most important don't use as a drumstick to your favorite song, this is very bad and has dire consequences.
Try taking some tape and wrapping around the area where the glass tank joins the top and bottom metal parts. I have had a couple that do not seal correctly and allow the head to flood. a wrap of clear tape fixed that issue for me.
just asking...wouldn't i get some leakage or maybe bubbles from the bottom if that were the issue? not arguing by any means,just a question...
in the meantime,i will try that
Actually no, if the fit is only slightly out. the Vacuum from Drawing can Force air to be drawn past a weak seal.
Think of like a sheet of paper holding water in an upside down glass. It works but it is not a tight seal and anything can disrupt it.
what vg/pg ratio is your juice? i find that too thin of liquids will often do this and the best ratio for protanks is about 50/50
- Status
Similar threads
- Locked
- Locked
