ok i just got 3 new attys after almost 3 months all my attys are pretty much dead........ so i got new ones, screwed it on put a cart on and started vaping and all i get is a dry, kinda burnt taste....why??? and its a full cart i used.......so i take it off drip a few drips on the atty the put it back on...so i get good flavor for a few hits then dry burnt taste again......wtf, do i have to do something to new attys B4 i use them or what??? plz i need help with this
HELP!! plz!! i got a question about new attys!!!
- Thread starter MMAfighterNH
- Start date
- th_trl_thread_readers 0
- Status
Sounds like your atty is dry and you need to add a few drops right on the bridge.....I only drip now and no more burnt taste!
It's always good to blow out the primer fluid in your new attys before use... but to me it sounds like you have a wicking problem with your cart. IMO, just drip.. but if you're set on carts, use PTBs. All my e-cig headaches were caused by using carts and leaking...
Sometimes it takes 2 or 3 dry burns to get the packing primer off. Sometimes you just have to wash 'em.
Good Luck,
NB
Good Luck,
NB
Some new attys come with a crappy primer on them, you can either dry burn it off or you can stick the aty in alcohol 100 proff vodka and soak them for about 15 min or you can boil some water and let the atty soak in that. If you do this it will take some time for the atty to dry some people put them in the oven at 150 degrees for about an hour. drop a few drops on the bridge and u r ready to go.
Also make sure you did not trim your PTB too short. If it isn't slightly touching the wick in the atomizer it won't wick the fluid down and thereby give you the nasty burn taste. There are a few 510's that the bridge is a bit shorter on and this could be the problem.
Last edited:
i dont kno what to do!!! i blew it out let it sit, i tried a few 3 sec dry burns nuttin works unless i just keep dripping................
If dripping gets the job done, and carts don't, it seems like it would be a cart problem, not getting the juice to the attie.
Either way, I noticed the same bad taste from my new atomizers, which wasn't present in the kit I bought. I soaked them in an alcohol/vinegar solution, rinsed them out and dried them in the oven at 190F for 20 minutes, and they "work like new".
Either way, I noticed the same bad taste from my new atomizers, which wasn't present in the kit I bought. I soaked them in an alcohol/vinegar solution, rinsed them out and dried them in the oven at 190F for 20 minutes, and they "work like new".
- Status
Similar threads
