I just used a SmokTech RSST on my brand new Vamo V3 and now nothing else will work with it. ...??? Can someone please tell me why this happened and what I can do to fix it??
HELP!!! Used a RSST On My VAMO V3 and Now Nothing Else Works On It
- Thread starter nettles4349
- Start date
- th_trl_thread_readers 0
-
- Tags
- vamo
- Status
http://www.e-cigarette-forum.com/forum/vamo/375871-vamo-ohm-error-fix.html
Check that out. It's for the V2 but probably applies to the V3 as well.
Check that out. It's for the V2 but probably applies to the V3 as well.
Did you screw it Down Hard to make it work when you used it?
You might have Pushed the Center Post Down?
Yeah, probably the center post. Use a toothpick and just run it around the center post until it releases. A fairly common occurrence, and an easy fix, after the fright resides. Good luck. If that doesn't work, report back and we can get this fixed. Has to be a connection problem.
First Thing to do. Take the Battery/batteries out of your Vamo.
Now you need to Raise the Center Post. Some poke the side of the Center Pin with a Stiff Pin or Needle and try to pry it Up Slightly. Might need to do it at 12, 3, 6 and 9 O'clock
Other people use Tweeters and Gently Up straight up on it.
Either way, you don't need to Lift it Much. So Go Slow.
That should be the problem next time before screwing rsst on vamo make sure the rsst connector pin is not protruding to far out. Unscrew positive post to adjust the pin it just needs to touch. Mine sits flush on vamo and Svd
Sent from my GT-I9300 using Tapatalk 2
Sent from my GT-I9300 using Tapatalk 2
IT WORKED!!!!! Thank you all so much for your help and input. I was really scared that I totally ....ed up my new (and first) APV. Thank you, thank you, thank you!!!
This also happened to my Vamo and I raised the center pin also, but it eventually stopped reading attachments again, it wasn't until I went to home depot and replaced the O ring that it became a (hopefully) perm fix. So just be careful with the screwing for now but just remember if it goes out again to look at replacing that O-ring.
Cool. Good to Hear your Back in Business.
No Thanks Needed. I get 250 Good Karma Points for Every mod I can Help get Up and Running Again.
And that a Good thing cause I'm working on Balancing the Scales after that School Bus/Nun thing.
BTW - Learn from what Happened.
Before you Screw Anything onto a PV, take a Quick Look to Make Sure the Center of the Atty or Clearo or rba isn't Sticking Out much more than the Threads.
And NEVER screw anything down Tight. Just Firm. Never Tight.
Geez, I'm glad I stumbled across this thread since my RSST should be arriving in the mail tomorrow. Now I know to check the center pin before jamming that sucker on my Vamo in excitement.
- Status
Similar threads
- Locked
