Help with DIY

[Steve K]

I received my first bottle of 50/50 pg/vg 12 mg nic from Ecigexpress and just wanted to try it straight out of the bottle and it seems to not be wicking very well and looks thick.Then upon adding some PG flavoring it still is not vaping well,what is wrong here???this is my only real source of juice at this point.I figured that if the juice was pre made at 50/50 it is good to go and shouldn't be thick or non wicking.

 

[Eddie.Willers]

Well, 50/50, in my experience, should be just fine in most (but probably not ALL) cartos/clearos etc.

What setup are you using? Have you tried a primer drop onto the coil? Did you let 15 minutes go by after filling to allow time for the juice to wick properly?

 

[markfm]

Did you shake the bottle? That's a good general practice, to make sure things are mixed, haven't separated.

 

[jimmyh]

I use 50/50. Before mixing I always put my bottle in hot water for a couple of minutes and then give it a shake or 2 to mix it up. If it is stored a cool to cold place I have found it does thicken up a bit.

 

[glassmanoak]

Are you using a carto? a tank? an atomizer? What??

 

[Steve K]

I will try these suggestions and post my results,Thanks!!!

 

[Steve K]

O.K it ended up being the vivi nova head,changed it out and got awesome vape,Thanks everyone.

 

[gcvt]

O.K it ended up being the vivi nova head,changed it out and got awesome vape,Thanks everyone.

Was it just worn out or did you get a dud?

 

[Steve K]

It was Worn out.