Hi im.... Probably goin to sound dumb

[Drewsloop]

Ok. If i have a parallel single coil build, with 4 post holes, could i run each lead into its own hole? Ive got?the csmnt rda so it would work as far as placement. Im not tryin to guinea pig my mod tryin though.

 

[Izan]

Ok. If i have a parallel single coil build, with 4 post holes, could i run each lead into its own hole? Ive got?the csmnt rda so it would work as far as placement. Im not tryin to guinea pig my mod tryin though.

Hi Drew,
Welcome.
Sure you can but then you would need to separate the legs and stuff them into each hole. And the net result will be...exactly the same as if you put both leads in the same hole but now it's harder to wick. (Pesky coil legs...)
I will presume you do not have the RDA in front of you (nor wire) to try the build and this is a hypothetical question.

Cheers
I

Please add your location to your profile so that we may offer location specific information.

 

[Drewsloop]

I actually had it all bolbolted down but chickened out of tryin it. Just had the legs comimg off at tje angles i needed. At work now so pic later

 

[Letitia]

Hello Drew. I'm confused as to why you would want to separate the legs.

 

[Izan]

I actually had it all bolbolted down but chickened out of tryin it. Just had the legs comimg off at tje angles i needed. At work now so pic later

Love it!!
Try everything twice...The first time might have been a fluke.

Welcome!
I

 

[Drewsloop]

I wanted to do it to take up some of the empty space and give it a stance... I guess

 

[Letitia]

I wanted to do it to take up some of the empty space and give it a stance... I guess

Use your wick instead, works well and easier to play with.

 

[Drewsloop]

I know but imo there is a level where you have too much wick

 

[Letitia]

I know but imo there is a level where you have too much wick

That's where sculpting enters into the equation. Try it, makes a difference.

 

[lupinehorror]

That's where sculpting enters into the equation. Try it, makes a difference.

this. often less is more. airflow matters.

 

[BrotherBob]

I know but imo there is a level where you have too much wick

Welcome and glad you joined.
Yes, for RDA's, touching or just short of touching the bottom of the posts bottom/base is a good length. Wick lengths for tanks, vendor's recommendation (usually, just touching the juice holes). Wick diameter, just slides through the coil without deforming the coil. Any wicking more, can trap and waste good juice when wick is changed. Too much wick in RDA deep well base can take up unnecessary juice room in the base and lead to more frequent juice filling. Too much wick is a waste of the wick material to name a few.