hi

Status
Not open for further replies.

mans_eng

New Member
Aug 20, 2018
2
0
i bought vaporesso tarto nano long time now
it was as working very good but i left it like one and half month without using it
now when i tried to use it again i found that the screen is not working all the time
but the vape is working
but sure ican’t access vape settings
is it software problem or what
kindly advise!!!
 

Attachments

  • 15C0DA97-CBA2-43F9-A5DD-C2A29979849F.jpeg
    15C0DA97-CBA2-43F9-A5DD-C2A29979849F.jpeg
    1 MB · Views: 13
  • Optimistic
Reactions: stols001

stols001

Moved On
ECF Veteran
May 30, 2017
29,338
108,120
I have a tarot nano but I can't really advise much from the looks of it the battery is almost fused with the board and there's really nothing even to disassemble. If you left it sitting a long time with the battery almost discharged, I guess the battery may be dead, I'm assuming that could be part of your problem or if you left the tank on the vape and full, maybe some eliquid got down through the 510 pin, IDK. It sounds like an annoying problem to have. You could check and see if it's still under warranty and warranty it if it is, I guess. Otherwise, you could take it to a vape shop if you have one near you that is good with electronics and they might be able to diagnose it for you, emphasis might.

I like mine quite a bit for what it is, it's an internal battery setup and I have long accepted that it's not going to last forever, same as with any vape (although, I think many mods with removable batteries last longer, due to being able to replace the batteries, and not constant wear on the USB port and etc.

If you like it enough, maybe you will purchase another one and yes the tank should continue to work on other mods, and yes, Vapresso and other mod makers make a nice selection of other types of mods . If you like the tank on your kit, you could certainly keep it and just replace the mod, etc.

Anna
 

mans_eng

New Member
Aug 20, 2018
2
0
Welcome to ECF. Many here do tho, I'm sure someone will come along woth an idea. It could be the battery is simply dying. If that is the case you will have to buy another device. Your tank will work with the new mod.
many thanks for reply
but my vape is working but the problem is only the display
i think maybe software!
 
  • Optimistic
Reactions: stols001

Letitia

Citrus Junkie
Supporting Member
ECF Veteran
Apr 2, 2017
26,325
139,920
West Frankfort, IL
many thanks for reply
but my vape is working but the problem is only the display
i think maybe software!
You could go to the Vaporesso website and and see if your mod has firmware support. Without the screen I doubt you could do a factory reset without a computer.
 
  • Agree
Reactions: stols001

BrotherBob

ECF Guru
ECF Veteran
Dec 24, 2014
14,252
12,511
Sunnyvale,CA,USA
but my vape is working but the problem is only the display
i think maybe software!
Welcome and glad you joined.
You are probably correct. Suggest you let it re charge for 4-6 hours and see if there is a change. Some battery failures might fall under the saying "use them or lose them". A month and a half with no charge (no telling what charge it was put away was, and if the there was any current leakage) could not help a battery/circuits.
 
  • Useful
Reactions: stols001
Status
Not open for further replies.

Users who are viewing this thread