On another note I thought I would share a little about how the feed system is sealed. This was sent in a PM but I thought I would share it with all.
The hole in the catch cup is drilled out smaller than the atomizer connector. Then the connector is press fitted into the catch cup.
After that, the hole in the top of the wood is filled with Loctite epoxy and epoxy is applied all around the underside of the catch cup and connector then it is mounted in the Mod.
When the connector is clamped into the mod excess epoxy oozes out from under the catch and is quickly wiped off before it damages the finish.
After that, the atty connector is completely epoxied around the inside of the mod. The result is a compression fit, completely epoxy filled connection all the way from where the bottle tube hits the stainless steel connector tube straight up to where the atty makes contact when you screw it in.
Now The epoxy I use does have a shine to it. Since the bottom edge of the catch cup is slightly rounded, it does leave a shine around the bottom edge of the connector where it hits the top of the Mod. This almost looks like juice is leaking.
You can see what I'm talking about here in this pic.
took me like 20 pics to get my phone to focus this close =(