How are the Vaporescence tanks?

[flbutterfly1]

I have been looking at the 3ml in both SS and aluminum. I was wondering if they leak? are they easy to take apart and fill ? I have been using Stormy tanks and I like them but would like to invest in a regular carto tank instead of a ce2 tank. I really want a metal capped tank and not a delrin or grommet tank(this is what I have and it'd ok but would like something diff). I chose this tank because I can get tank tints for it, metal caps, and I like the size. Just looking for some input from anyone that uses vaporescence tanks. Thanks

 

[mergryphon]

I love my 8.5ml aluminum BFT tank from Vaporesence. No leaks, tops come off easily enough for quick carto changing or refilling.

 

[st0nedpenguin]

You can also switch cartos by just pushing the fresh one up into the tank from the battery end, it slides in and pushes the old one out with no mess whatsoever.

I've been using mine for ages now and I love it.

 

[player30]

Although I have four, I am still using the same one I started with 4 or 5 months ago. No mess. As a side note, I use it with Ikenvape Fusions, and so I get a nice stop mark on the tank, and I don't have to worry about my tank slipping down.

 

[Hottody]

I have a Vaporecence 3.5 tank and no leaks! The o-rings seemed to be too tight so I replaced with the spares! It was just hard to put the caps on at first! Other than that issue, I would never do without my tank now!! Also I do not own the aluminum version!

 

[djej]

I have a Vaporecence 3.5 tank and no leaks! The o-rings seemed to be too tight so I replaced with the spares! It was just hard to put the caps on at first! Other than that issue, I would never do without my tank now!! Also I do not own the aluminum version!

I literally could not get the end caps on AT ALL. I live about 20 minutes from them, and I was so aggravated that instead of driving back to the store, I got my dremel and bored out the inside edges of the tube ends. I did it little by little as to not create TOO much space. The caps are still a tight fit, but they finally went in.

If I knew that was even a concern, I would have made them show me that the end caps come on and off with some sort of ease. At one point, I was standing on the tank (with the o rings "lubed" with e juice), and it still wouldn't seat!!!!!

Oh well, not many people have complained about this, so it's probably somewhat of an isolated incident.

 

[Killjoy1]

I have an aluminum one, works fine just like all the other available tanks My only gripe about them is the carto is too loose in the caps and the caps are a little loose in the tube, I've pulled the tank right off the carto once. It's only a minor gripe, though. They are fine tanks, but not my preferred ones, personally

 

[flbutterfly1]

Thank-you for all the responses. I have made up my mind I am going to get the 3ml with SS caps. Should I go ahead and order an extra set of rings with it?

 

[Killjoy1]

Can't hurt. They're cheap and it's better to have them just in case ;-) They do wear over time and there's always the chance of damaging one while inserting a carto

 

[flbutterfly1]

Ok guess I will get the extra rings too. Thank-you.