How to fill kbox 160watts slight leaking

Status
Not open for further replies.

rcalvy1

Super Member
ECF Veteran
Oct 25, 2010
568
188
43
canda
Hi guys,

thanks for all your advice on my last post! I did end up purchasing the kangertech Dripbox 160 and loving it! Quick question when you fill up the little squonker bottle how much do you fill it? Is it normal to get a bit of leaking on the inside of the bottle housing? Nothing leaks out of the box just when I take the tank out to fill it up I notice the little magnet cover that holds the tank in place is always wet, also sometimes I will notice juice around the edges of the top of the tank.

Thanks!
 

Cheallaigh

Ultra Member
Aug 13, 2016
2,281
2,954
54
Georgian Bay, Ontario
you fill to the top of the main part of it, do not fill the neck. depending on how forcefully you squonk, and even sometimes then.. they can leak a little from the neck area, as long as it's only tiny dribs and drabs it's okay, just wipe it up when you see it. juice around the rda part is usually from over-squonking, as in you put so much up top it's managed to get to the air vents. they have a pretty large driptip so you can see inside when squeezing, watch it when you do it, till you get a feel for just how much you need... takes a bit of practice.
 
  • Like
Reactions: rcalvy1

pwheeler

Just Vaping
ECF Veteran
Verified Member
Nov 14, 2013
9,157
31,761
68
Weimar, TX
That will do that if you have a bubble in the bottle keeping juice at the top of the hole. Wipe the top of the bottle and that breaks the surface and the juice goes back inside. I always fill mine just about to the top of the bottle just before it goes down to the threaded part.

Sent from my HTC Desire Eye using Tapatalk
 
  • Like
Reactions: rcalvy1

pwheeler

Just Vaping
ECF Veteran
Verified Member
Nov 14, 2013
9,157
31,761
68
Weimar, TX
The bottle does just push onto the white plug thing. Like I said, make sure you dont have any juice covering the opening of the bottle. Oversquonking would normally make a mess on the outside of your mod, not so much on the inside. Of course, you could have a bottle with a slight defect in it causing some slight seepage.

Sent from my HTC Desire Eye using Tapatalk
 
  • Like
Reactions: rcalvy1

rcalvy1

Super Member
ECF Veteran
Oct 25, 2010
568
188
43
canda
The bottle does just push onto the white plug thing. Like I said, make sure you dont have any juice covering the opening of the bottle. Oversquonking would normally make a mess on the outside of your mod, not so much on the inside. Of course, you could have a bottle with a slight defect in it causing some slight seepage.

Sent from my HTC Desire Eye using Tapatalk
Thanks so much. Problem solved I was filling the bottle right up to mid neck. The volume of the pin and white thing were making it leak a bit.
 
Status
Not open for further replies.

Users who are viewing this thread