Hello all! I just ordered a new Innokin Coolfire z80 kit that comes with a free 30ml bottle of 70Pg juice. My question is; how can I make use of this juice with my sub ohm setup? The kit comes with a .3 ohm coil and a .8 ohm coil. But I usually use .48 ohm and .5 ohm coils. I'm hoping to make use of the juice without it being unpleasant.
- Status
Can you get another bottle of the same juice with a different PG/VG ratio, then mix them?
Welcome to ecf
.
Hi and welcome,
You can dilute the juice (flavor and nicotine strength will change also) with some pure VG. (pharmacy/Bezos)
IMO, If the nicotine level is not too high, the juice should be fine in the new coolfire.
HTH
I
No I can't. This juice comes from the other end of the country. I mistakenly assumed that the 70/30 was Vg/Pg, not Pg/Vg. And apparently all their inhouse made juices offered are 70pg/30vg.Can you get another bottle of the same juice with a different PG/VG ratio, then mix them?
Welcome to ecf
So in a nut shell - it will be more runny and less cloud.
What exactly is the issue here? The resistance of the coil makes no difference.
g.
What exactly is the issue here? The resistance of the coil makes no difference.
g.
I'm fairly new and I've been told that this high vg juice would be really unpleasant to vape.
It depends on the tank. I believe it came with the Zenith II. If I recall, the VG should not be more than 50% for best results.
I am slightly confused here.
If it's 70/30 VG/PG, it'll vape just fine with all Z coils.
If it's 70/30 PG/VG, then it's going to be less viscous and lower Ohm coils which often have much larger juice ports built into the coil heads may end up seeping through your coil causing your chimney to flood. Flavor wise, you can expect a stronger throat hit and less vape clouds.
What smacuser was saying was, if you can purchase 70/30 VG/PG juice from somewhere else or some other brand, you can dilute the higher PG juice into the higher VG juice a little at a time as to not waste it or throw it out.
Last edited:
If u dont use the 0.3ohm mesh coil or the 1ohm that are for direct lung and u use any of the mtl ones u wont have any problem and actually it may works better than using any 50/50 vg pg or 70/30 vg pg juice.
Even tho i find it hard to believe they ship u a juice with 70pg 30vg and most likely its 70vg and 30pg either way tho u can vape it no matter if the coil is under 1ohm as u said subohm
Even tho i find it hard to believe they ship u a juice with 70pg 30vg and most likely its 70vg and 30pg either way tho u can vape it no matter if the coil is under 1ohm as u said subohm
Innokin claims the z coils can use from 70vg up to 70pg but in reality in my opinion the mtl coils have a hard time use 70vg and when i use them i use 60pg juice and 50 works fine ofc also so yeah i agree its better not use high vg with them for best results
The juice comes from Canada Vapes, and I emailed them to clarify. But the fella that responded says that all their inhouse made juices are 70PG/30VG. It's the free 30ml that comes with some of their kits.
That’s what I do for my evening vape juice. Plus I prefer max VG which is how I mix it but I still use some VG/PG.
Oh I'm sorry - I miss read - its %70VG NOT %70PG!!
I'll say that your talking to the wrong person then.
I vape %90-VG/%10-H2O.VG has a somewhat natural 'sweetness' to it and produces more "cloud" then PG does so juices with high VG content will produce more vapor.
Assuming that your using factory coils right?
So assuming that the same exact wire type and inside diameter is used, coils with higher resistance have more windings (more wire) then coils of lower resistance.
When it comes to vapor production it comes down to temperature and surface area. So assuming the same wire, coil type and inside diameter a coil with more windings (higher resistance) will have more surface area and produce more vapor.
Pure %100VG can be to 'thick' to wick very well so I add a bit of water to thin it out making it pour and wick better.
Actually what I'm vaping right now is %90-VG/%10-H2O (no flavoring at all).
g.
Welcome to the fray, Will.
I'm sure you'll figure out how to use the sample. It's a matter of mixing it with something else in higher VG, same nic level, maybe even a different flave, from another seller. I hate it when a seller doesn't offer options.
Best of luck to you.
I'm sure you'll figure out how to use the sample. It's a matter of mixing it with something else in higher VG, same nic level, maybe even a different flave, from another seller. I hate it when a seller doesn't offer options.
Best of luck to you.
If you are OK with Lowering the mg/ml of the e-Liquid you have, this is one way to Change It.
Help! Accidentaly ordered 70 PG!
- Status
Similar threads
- Locked
