HV Iatty Coil?

[Torqueguy]

I tried to search the forum on this topic but couldnt find much.

Can someone recommend a good combination of wire and wick for HV coils? I've been getting a couple hours out of the ones I made thus far but think that there has to be a better combination. I vape at 7.4v and would like to get some more life and a bit less heat

Thanks

 

[imeothanasis]

4-4,5 ohms torq

 

[RippleInStillWater]

I think the best way to get that much wire wrapped is to double the wick at the cup (a separate shorter piece) and have the cup modified like Rick45cal did so there is enough room for the larger wick.........

 

[imeothanasis]

Or use a thin R wire like 0,13 or 0,1mm

 

[Torqueguy]

Ok, thanks. I have a diamond file that might remove some ceramic. I have thin wire but i can't seem to get enough wraps.

 

[imeothanasis]

Not a problem if you cant make many wraps Torq. The less wraps the better because they will fit nice inside ceramic

 

[Poppa D]

Use standard wick and 36ga coil at 3.5 to 4.5 ohm or better seems to work for 24 to 48 hours at 7.4 volts w/sweet dark VG.

 

[Torqueguy]

Thanks, I'll try that Poppa

Use standard wick and 36ga coil at 3.5 to 4.5 ohm or better seems to work for 24 to 48 hours at 7.4 volts w/sweet dark VG.