QUESTION: Tips - Advice on new DEAD - HV Atty?

Status
Not open for further replies.

Mactavish

Ultra Member
ECF Veteran
Verified Member
Jan 19, 2010
2,051
3,649
New York
I killed 2 atties in 2 mins because I overfluid them to make some leaking tests. Maybe atomizers dont like this configuration:D

Yes, perhaps too much can "short out" the HV atty, or like anything else, could have received a "bad" one, that worked at first. I sure won't be adding 40 drops to empty carts anymore, 20-25 drops seems right in a 801 cart when new and empty, topping off after the first full fill. Have not had a problem since, don't have a 2nd 801 HV atty, which is too bad, the first few vape before failure sure put out a lot of vapor, it was soaked! :)
 

imeothanasis

Unregistered Supplier
ECF Veteran
Feb 13, 2009
47,882
34,510
Athens, Hellas
gg-goldengreek.com
Yes, perhaps too much can "short out" the HV atty, or like anything else, could have received a "bad" one, that worked at first. I sure won't be adding 40 drops to empty carts anymore, 20-25 drops seems right in a 801 cart when new and empty, topping off after the first full fill. Have not had a problem since, don't have a 2nd 801 HV atty, which is too bad, the first few vape before failure sure put out a lot of vapor, it was soaked! :)

You will stop carts after AFS for sure so dont worry too much about them Macta:)
 
Status
Not open for further replies.

Users who are viewing this thread