I am still really not understanding how to use a mechanical mod safety (ohms)

[JGonzo]

Oh, and don't make the n00b mistake that I did and confuse mAH with mA. If you use the water bottle example from elsewhere, mAH are the battery's capacity (how much water it holds) and mA are how fast it can safely discharge (how fast it can pour). Excessive conflation of the two measurements can lead to explosions.

 

[jayn]

It's pretty hard to screw it up, if you run sub ohms you just need to know that you can't be chain vaping it for extended time. I run .2 and it's fine, I just monitor the battery heat

 

[Skyfntm]

Ok so if I wanted to use a mech with a aw imr 18350 the lowest ohm I would want is 0.9 to have a good buffer

And on an aw imr 18490 the lowest is 0.5 for a good buffer.

Based of max charge @ 4.2 volts.

Is this correct? If not I need to go back and re-read this thread lol.