I opened up my airhole to large and my reo is now too airy it feels like just dirty air - maybe nj air

[flexsr]

Hey guys, i drilled out my single airhole on my rba/rm2 for my reo grande larger than stock, possibly The dumbest thing i ever did in my life- what a numbskull. -Not sure the dimensions but OMG this airy vape is just horrible to me.

Before doing this i never realized i was a warm vapor strong throat and that i liked to draw into my mouth then my lungs vaporer!!! . I always just did this automatic and never thought about it in the past.

Is there Temporary fix someone can think of to decrease the airhole size to allow for warmer more dense mouth to lung vaping .


I had posted about this problem before and had one decent solution but i going nuts trying to find it.

For the love of god is there a fire ......ant clay i can use lol ? There has to be a way to reduce this airflow. I just not smart enough to figure it

Thanks for listening guys

....Head held down in shame....

 

[bstedh]

Use a piece of metal and bend it to a curve just bigger than your dripper and put inside the cap with the spring tension holding it in place. Position to partially block the air hole.

Sent from my HTC One using Tapatalk

 

[flexsr]

Not sure I follow - I have an rm2 rba - it's posts on inside and just one outside cape - this outside cap has a a hole drilled in through the side that's suppose to line up with atomizer. I made the whole bigger like a smuck - my vaping preferences require a tiny hole - warmer mouth draws etc

You may be thinking of a different type of rba or I too stupid to understand -

Thx buddy - will re read later n see if I get it -

 

[bstedh]

Another quick fix is a piece of tape over the hole.... Poke a hole in it... As for the previous think the same as above only with a piece of metal on the inside instead of tape...

Sent from my HTC One using Tapatalk

 

[Katanakaji]

fill the hole with epoxy, then re-drill to a smaller size

 

[flexsr]

Thx for the replies !

 

[talon4x4]

Why not try some JB Weld on the outside?! If you use a small amount it shouldn't be too noticeable. I'm not sure what exactly is in this stuff so I'm not sure if you could use it to cover the hole from the inside. This stuff dries rock hard and can withstand extremely high temps. I've used it to fix small cracks in an exhaust manifold.

JB Weld | World's Strongest Bond

 

[trouble1000]

Or maybe you could roll a small piece of mesh and put that in the airhole that way you can fine tune the size of the mesh filler to get your perfect vape. Just be careful that you don't push the mesh in too far and cause a short

 

[flexsr]

I believe I found the perfect solution from a member- ill post a link to the thread below for anyone coming across title of thread and ln need of the same help..I haven't tried it yet but it seems perfect.

Thank you to everyone who responded with your awesome ideas above - !!

Post #24 on link below seems like best answer - shall try mañana - thx zmauls

http://www.e-cigarette-forum.com/forum/showthread.php?t=532187

 

[bstedh]

my idea was almost the same just hidden on the inside...

Sent from my HTC One using Tapatalk

 

[flexsr]

Oh yeah first post you said would work - I wasn't getting what you were saying at first until now - I gotcha now -) ... (Except the spring might run into the kanthal vaping coil inside, no ?- MY FAULT for not including pics ! - I'm sure there could be a work around) -

I have to do something good for the world now--- with all the chaos and tribulations my biggest nightmare has been the size of my airhole for my rba "ruining" my life