I think he means there could have been a hot leg for a moment but it worked itself out. I've had that happen before. As long as it's reading a consistent ohms now I wouldn't worry. When a new coil first fires up it may fluctuate for a second until the wire gets fired up good.
Hot spots or loose screws, for sure. I've experienced it a lot of times. Those first 1-10 fires on a newly-wrapped coil, the resistance will usually be all over the place. I've seen coils read .5 and then 2.5 and then finally settle on their true resistance at 1.0.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
