I tried everything, still cant fix.
- Thread starter CaptainR3AP3R
- Start date
- th_trl_thread_readers 0
-
- Tags
- everything fix
- Status
if the mod is bad, you should have gotten a short error message... but since you got a no atomizer error, the mod is ok
Which coils/heads are you using?
There is a .15Ω Ni and a .5Ω Ti that must be used in Temp control mode.
Are you using an RBA? wrapping/building your own coils?
If so what wire type & resistance?
There is a .15Ω Ni and a .5Ω Ti that must be used in Temp control mode.
Are you using an RBA? wrapping/building your own coils?
If so what wire type & resistance?
Ok i said no atomizer only when i take atomizer off. When its on and i press button it says atomizer short, that was to clarify it xD. I have to try with a higher resistance coil, around what resistance should i aim?
I used default coil that came in the box (the reserve one)
Okay, what does it say on the body of the head? what resistance is your Pico reading?
what is/are the ohms of the coils you are using??? you never mentioned that point....
Are you sure you are not using a tc coil in wattage mode or have mod in tc with a non tc coil?
..... Im not home atm xD il check and write here when i come home not much from now. But i think its around 0.35
its gotten down to the process of elimination.... and there are alot of things to eliminate 
Im gonna try and change the mode when i can cause i cant rn.
Ye ty.its my first vape xd so im not very experienced. Il write the ohm try change mode and try swapping the coil to higher resistance, if that wont help il either take it to a store or just buay a new one xdits gotten down to the process of elimination.... and there are alot of things to eliminate
Your screen should tell you if you are in tc mode or not and the coils should have something stamped on them or have different colored o-rings if tc coils.
Ye i cant check rn cause im not home. Colored o rings? The base atomizer had whit orings and a coil i changed coil for the reserve one but they look EXACTLY th same. But i have 2 pink reserve orings that came with the box.
Just the individual o-ring on the base of the coil itself. Others are spare for the tank, not the coils.
May be a good idea to refer to the instruction manual.
The screen will show the resistance, the heads/coils are marked / printed with the resistance & recommended power range.
The kit usually comes with the .3Ω kanthal installed & a .5Ω kanthal spare both to be used in VW, watt/ power mode only.
What battery are you using?
(name brand, any letters & numbers on wrap, color of wrap)
Some malfunctions can be caused by use of an insufficient cell.
The screen will show the resistance, the heads/coils are marked / printed with the resistance & recommended power range.
The kit usually comes with the .3Ω kanthal installed & a .5Ω kanthal spare both to be used in VW, watt/ power mode only.
What battery are you using?
(name brand, any letters & numbers on wrap, color of wrap)
Some malfunctions can be caused by use of an insufficient cell.
The output to the coil is most likely driven by a largish transistor. They love to fail short. That component may have failed, they are very sensitive to static discharge. Again, it's very difficult to troubleshoot something like this without electronics experience and at least a voltmeter. If you have swapped out any user serviceable component, i.e., coils and batteries, and connections look good...it's the box. If any component internally failed, you're better off just getting a new mod, take it to your vape shop. They usually will swap you out one, they can get credit on their return.
- Status
Similar threads
