iAtty zero airflow on mod

[K24A3]

I've been using an iAtty on a Provari for days with no problem. Today I rebuilt a new wick+coil and now there is absolutely no airflow. The iAtty sits flush on the Provari which would obviously block the air, but it was working fine before.

The iAtty works on other 510 batteries, and other Carto's work fine on the Provari.

I'm guessing the inner battery contact in the iAtty has moved up a bit, how do I adjust the inner contact position?

I ensured the plastic threaded parts are tight, but not too tight since I don't want to damage the wires.
I tried unscrewing the inner contact but it wont budge.

 

[CarolCrocbag]

Similar thing happened with my Don. It was fine at first, not loose at all and adjustable. It was the firing pin contact on my don that shifted, iAtty won that battle.
Not sure how you would go about fixing it on the Provari.

 

[eyebrook]

The Iatty did the same to my Bulli extreme centre pin, but I managed to lift it up again

 

[K24A3]

It's all good now, I managed to fix it.

The wire that wraps around the lower post was looped all the way around. I cut most of the wire off leaving about 2cm which let the inner contact move down further.

Thanks anyway guys.

 

[Para]

I've been using an iAtty on a Provari for days with no problem. Today I rebuilt a new wick+coil and now there is absolutely no airflow. The iAtty sits flush on the Provari which would obviously block the air, but it was working fine before.

The iAtty works on other 510 batteries, and other Carto's work fine on the Provari.

I'm guessing the inner battery contact in the iAtty has moved up a bit, how do I adjust the inner contact position?

Rather than guess and move things that could make things worse; get a GOOD look at the air holes and center post.
I found one of the air holes with a metal obstruction from the milling/drilling process.

If you don't have a lighted magnifier; it's some of the best money you can spend

Prices start online for less than 10 bucks and worth their weight in gold for troubleshooting in tight areas. I've got several models and all get used just about every day.

 

[K24A3]

I have a magnifier like that, the holes are quite clean.

The problem was just doubled up wiring causing excess spacing.

Cheers

 

[CarolCrocbag]

I just had too. Won mine at the local auction rooms a couple of weeks back, for three quid. Always wanted one.