Iclear 30 holes do not line up with groove

[Towman]

the two holes do not line up with the grooves on the bottom of my iclear 30. anyone have a fix for this?

 

[PaulBHC]

This may be on purpose to cut down on noise. It will work fine the way it is. Mine do.

 

[Markill]

Mine works fine, and it looks the same

 

[Towman]

Im thinking this may be the problem with the limited air draw these tanks have. I have seen some ongoogle images that did line up. Im almost ready to cut a new groove with a drimmel as an experiment.

 

[PaulBHC]

These just have a tight draw. The air goes through the little holes on the 510, then through the pin in the bottom of the coil head and then the rubber cap on top.