IGO-L Recommend for hot days

[Visus]

A while back I had all kinds of atomizer issues in the heat of the day, they were leaking like a sieve. Many said get the IGO-L it definitely wont leak on you. My delivery came yesterday and lo and behold it was 97 degrees here, it did not leak one bit, my genny leaks and how it does that I have no idea maybe the silicon or orings idk-- are worn a bit but they look like new. This is the first atomizer that I have gone all day and not a single bit of e juice on my hands. Only a small amount on the airhole with vape backup and thats it! Awesome flavor and vapor...


You guys,

 

[ImThatGuy]

Dripping atomizers like the IGO-L should not be flooded. The wicks should only be saturated enough to vape with. Gennys have tanks so with increased temperature there is an increase of pressure inside the tank causing a "push" on the liquid. To my knowledge that is...

 

[Visus]

Yeah with the genny it seems like it's leaking from the bottom oring then it seems like its leaking from the top cap.

My IGO-L is ss meshed micro with a nextel sleeve in a U shape, it is an amazing atomizer it takes 20 drops, it may take more but im not going further. I do not get one dry hit until its bone dry, thats quite a few vapes.

The only negative is the solid post. I cannot adjust it so the airhole is always away from button on an ego.. I normally use my thumb for activation and now the crease of my pointer finger has the deed.

Looks really snazzy on a 650mah beauty ringed

 

[pdxtechdoctor]

Mind sharing a pic of your coil?

 

[ClippinWings]

my iGo-L leaks like crazy....

BUT it's only because my air hole is seriously bored out... so when i tilt it sideways I have to pay attention to keep the air hole up. I neglect this... often.

 

[Visus]

Mind sharing a pic of your coil?

my cam isnt up for the deed, but its a beaut 10/9 tight #32 nichrome 1.9ohm about a 1/16 ss mesh wick with the nextel sleeve you get in disposable on the u end of it..
wicks fast enough for not one dry hit chain vaping consecutives until dry.

 

[Visus]

I got the idea in the rba section, its the exact same as this build picture from google except im an uber pro coil builder..

This posted picture is not a micro coil or wick its a basic build but the premise is from that... You have to torch the ss mesh with a paper clip in or metal insert and slowly work the U or it will flatten and crease which isnt bad just isnt purdy but make sure your coil end has a rod to keep round shape.. after pulling out the rod it will straighten just a bit and you will need to shape it on fire again once or twice and after all did it will hold its shape..

 

[Visus]

my iGo-L leaks like crazy....

BUT it's only because my air hole is seriously bored out... so when i tilt it sideways I have to pay attention to keep the air hole up. I neglect this... often.

Im keeping this one stock my 650mah batts lasting 7hrs woot hella nice build on it. I am purchasing another L for a mech and will drill that one. My genny has a bore of 1/16 and it sometimes spits juice on my monitor. I can see it now at a card party and I am vaping, the spitting juice hits someone in the eye... I use my 510-t for such events though but watch out for that ..