Igo w on a chi you clone

[Tiktik]

Hi, I recently upgraded to mech mod. I have successfully rebuild couple times on my igo w using the same method. (Just a regular dual coil micro nano) on my ohms reader, it read 0.7 but if I put it on my chi you clone it won't test fire at all? I've been stuck, someone please help me out? I followed YouTube videos still can't fire.... I'm frustrated. I am back at vaping my protank now. Someone please help.
I'm using sony vtc4 on the chi you clone.


Sent from my iPhone using Tapatalk

 

[TrolleyVW]

Sorry but I had to read your post a couple times because of the poor grammar... To get answers, you probably need to state a clear and concise question.

Also , micro and nano are two different things.

Now that that is out of the way, I would start with your connections. The chi you has a dual adjustment positive pin. Make sure you screw the atomizer on first and THEN adjust the larger but until it stops spinning. Then, adjust the smaller screw down until your battery barely shakes inside the tube. You will probably have to disassemble and reassemble the device a few times.

If this fails, check your screws in your atomizer itself. Make sure all wires are right and secure. Make sure no legs have snapped.

Next, make sure your batteries are adequately charged and are not dead. To do this , use a multimeter or high quality charger and check the voltage. They should be between 3.7-4.2 ideally.

If all of these things check out, it is either your build , your other materials, or you've skipped a step.