Hey guys,
I'm new to vaping so I'm slowly getting to experience all of the methods available to vape. So far my boge/liquinator is my go to.
I just recently got myself a IKV I06 3.5ohm atty with a siam mods drip tip/shield and have some questions regarding its performance.
At first, I did as instructed on many reviews regarding dripping atty's ... blow out primer, 3-4 drops to prime, then top off with 3-4 etc etc.
But I'm finding that I have to almost flood it or flood it completely for it to perform properly. If not, I'm getting a very nasty metallic taste to any juice I drip into it. Vapour production is always good, but it gurgles like no tomorrow for it to taste good.
If I drip only the 3 drops = burnt, metallic taste .. pull off the shield and can immediately see that the coil glows orange within 1-2 seconds .. which I believe is a bad thing?
So is this normal for this type of atty .. needing it to almost be flooded to taste properly?
Hooked up to a ProVari running between 5.0-6.0v with a AO reading of 3.7ohms
I should also mention that when I first got it that the taste I was experiencing was totally unexpected and thought I got a dud. And so I decided to try some cleaning methods ..
-filling with pg/vg and blowing it out through the battery end .. numerous times
-putting it in boiling water for several minutes and blowing it out.
I'm new to vaping so I'm slowly getting to experience all of the methods available to vape. So far my boge/liquinator is my go to.
I just recently got myself a IKV I06 3.5ohm atty with a siam mods drip tip/shield and have some questions regarding its performance.
At first, I did as instructed on many reviews regarding dripping atty's ... blow out primer, 3-4 drops to prime, then top off with 3-4 etc etc.
But I'm finding that I have to almost flood it or flood it completely for it to perform properly. If not, I'm getting a very nasty metallic taste to any juice I drip into it. Vapour production is always good, but it gurgles like no tomorrow for it to taste good.
If I drip only the 3 drops = burnt, metallic taste .. pull off the shield and can immediately see that the coil glows orange within 1-2 seconds .. which I believe is a bad thing?
So is this normal for this type of atty .. needing it to almost be flooded to taste properly?
Hooked up to a ProVari running between 5.0-6.0v with a AO reading of 3.7ohms
I should also mention that when I first got it that the taste I was experiencing was totally unexpected and thought I got a dud. And so I decided to try some cleaning methods ..
-filling with pg/vg and blowing it out through the battery end .. numerous times
-putting it in boiling water for several minutes and blowing it out.
Last edited: