Hi guys,
I've been sent one of these to test, it's not the final product. This is a preproduction/engineering sample. Do *not* think this is an endorsement- I have not seen the final product.
Display:

Button:

510 Connector and juice Well:

End Cap:

Insides:

You'll note the lack of vent holes or spring in the end cap (they are supposedly there in the final production unit). The unit is not airtight however and air passes the button. The head of the init can take eGo-T A/B style atties and cartos natively- no eGo adapter needed. It does use PWM of some sort and 3.0 volts hits like 3.9 to me on a 2.4 ohm carto.
This unit throws "F2" errors occasionally. Supposedly they are working on it.
It's HEAVY. Heavier than a 3.7 volt Triple V (See comparison pictures in next post)
The finish is nice. I can endorse the *finish*.
More.....
I've been sent one of these to test, it's not the final product. This is a preproduction/engineering sample. Do *not* think this is an endorsement- I have not seen the final product.
Display:

Button:

510 Connector and juice Well:

End Cap:

Insides:

You'll note the lack of vent holes or spring in the end cap (they are supposedly there in the final production unit). The unit is not airtight however and air passes the button. The head of the init can take eGo-T A/B style atties and cartos natively- no eGo adapter needed. It does use PWM of some sort and 3.0 volts hits like 3.9 to me on a 2.4 ohm carto.
This unit throws "F2" errors occasionally. Supposedly they are working on it.
It's HEAVY. Heavier than a 3.7 volt Triple V (See comparison pictures in next post)
The finish is nice. I can endorse the *finish*.
More.....
Last edited: