Inferno Tank!! What is up with this thing! no draw!!!

[BigStick]

Never been so frustrated in my life!! Pre-punctured the tank, even took out the little tab left behind. Filled the tank, snapped it into the atty, screwed it on the battery...no draw!! take the tank and atty off, perfect draw. What am I missing here???

Be nice if Volcano would pack some @!#$%&_ intructions.

And my pass through doesn't work!!! Again, some @#$%&() instructions would be nice!!!

Didn't even get any button protectors!!

 

[Michael James]

Should have been a card inside that points you to a url with a video about the inferno and tankomiser. But as far as the button protector, a lot of models they are shipping now doesn't need it. If you hit the button 5 times quickly it will lock the button. The cover was for older models.

As far as the tank goes, are you getting any vapor at all? And is the button lighting up when you hit it to draw on it? Just want to make sure the button isn't locked off.

 

[BigStick]

Thank you, Michael. That took care of that. Wow, was starting to panic. I took a few drags of my Echo and that helped

I watched the YouTube vid before buying and did it just the way they said. I decided to blow through the thing and am now getting some air flow and vape. Tight draw though. I bought the drip, tankomizer combo, so at this point I'm dripping. How many drops should you start with? I think I went a little over at the start as I just got done cleaning juice

I also purchased a Tube Tank, that had instructions, LOL

Appreciate the help, Michael. My apologies to all for the rant.

 

[Michael James]

well the drip it's best to flood prime them, with the typical drip off a bottle if you don't have a needle tip, drop about 10-15 drops on it and let it sit on a paper towel for 5-10 min, clean it up then good to go, anywhere from 2-4 drops of a typcial dropper, I do 5-6 but I use the needle tip caps from them so drops are smaller.

On the tankomiser you can pull the end cap off the mouth end off and remove the air baffle to get a better draw, but if you pull too hard you will get a mouthful of juice, nothing to stop it. I leave both pieces off, I put the one on the end of the mouthpiece back on but almost choked to death when i bit down on it once and it popped out and shot down my throat. lol

 

[Michael James]

the flood priming makes em last longer, lets juice absorb into the material. I fried 3 attys my first day trying dripping before I learned.

 

[BigStick]

Flood prime it is then. I put about seven on the first shot, but I put what you recommended and am letting it sit.

Assume my Tube Tank will need to sit a bit as well after filling it up?

 

[Michael James]

not really what i do to quick prime, is before i even put the cart in the tank, will do the dripping in the cart, but when the top gets soaked, will put my mouth over the top and give a quick little puff and it blows it down the fill a little bit, just keep doing it that way till it doesn't go down with that little puff. using the drip and soak method could take 20-30 min, i get it done in about 5. but put a paper towel down under it, cause once it's full you might blow a little juice out the bottom. just clean it up, give a quick puff and blow through the thread end and good to go, pop it in the tank and fill er up.

 

[BigStick]

Thanks guys, appreciate the advice!

 

[BigStick]

Gaahh! Funny chemical taste coming from this TubeTank, should have washed it first.