Infinity help

[DaDoc]

hello all,

I was hoping a few people could help me i just got my infinity and it's not made for low res attys the lowest setting is 3.34v and the highest is 6.4 does anyone have any knowldge of a good carto or atty to use with this PV many thanks

vape On

 

[Debian Dog]

Why do you think you need a low res addy if you can adjust the voltage just curious?

3.7 volt vape at 2.0 ohms is a 6.845 watt vape

a 3.02 volt vape (The lowest your infinity goes) at 3.0 ohms is a 3.41335 wattage vape

Ohm's Law Calculators

i am in love with the IKV ones myself

Premium IKV 510 Cartomizer (Soft-Tipped) Platinum

 

[DaDoc]

i dont think i need a low res atty it's just what ive allways used so i dont really no any othere good attys thanks for the calculator though mate.


Vape On

 

[Debian Dog]

Others can verify but I think you are good down to 2.0

Beamed from my DroidX

 

[fray]

It can only handle 2 amps.

Standard resistant boge cartos work well with my infinity at all voltages

 

[mistinthewoods]

IKV 801 Fusion cartos are my Buzz's best friend.

 

[grandmato5]

Ikenvapes HV attys (3.5 ohms) work well on my Infinity. Also the 3.2 ohm attys at Madvapes. Boge 3ohm cartos aren't bad either and I'm not normally a BOGE carto fan. I really enjoy the vape on my Infinity.

 

[BuzzKill]

There is a good thread in the Notcigs forum here all about cartos and attys http://www.e-cigarette-forum.com/forum/notcigs/151940-cartoz-carts-e2s-etc-post-here.html

FYI

 

[DaDoc]

Thanks,

notcigs sent me that link in an e-mail think im going with madvapes right now give them a shot

thanks everyone

Vape On