Informal Poll: what vg level do you use in RTAs?

[Big Me]

It ranges from 50PG/50VG to 20PG/80VG dependent upon whether it's a vendor produced liquid (Manabush) to my own DIY or if they've been mixed together.

This is true in both RDAs and RTAs - I don't use sub-ohm tanks (that utilise premade coils)

 

[Light Seeker]

About 95% vg, better half is allergic to pg. My diy nic is a 50/50 base, some flavors may have pg, that's why I guesstimate a 95% overall (no pg added to recipes).

Usually use a kayfun v4 atty, roll a 2.8mm coil. Any smaller and it starts to get restricted, need larger ID coils for the thick goo.

Sent from my HTC One using Tapatalk

 

[Roadtrip635]

Most of my juice is 70%-80% VG. I do have a couple juices with higher VG, but I usually drip those. I normally don't have any issues with those in RTA's either, usually just needs the tank to heat up a bit. I use organic cotton to wick. I use a STM with the RBA deck, OBS Crius, SXK Nebula Wine Tank and Geekvapes Griffin.

 

[SpyderBite]

I have 50/50 and 65/35 vg/pg for retail juice and my DIY is always 40/60 vg/pg. For some reason my DIY just doesn't have the same throat hit that I like so I increase the pg.

Taifun GT-2 RTA.

 

[Adam harris]

50/50

If I'm feeling frisky then 70/30

 

[Djoof]

80-90%VG for all juices
Kayfun Lite, Monster, Axiom hybrid

 

[VapingTurtle]

70p/30v mostly

kfl mostly

 

[HighPlainsPuffer]

50/50 here for everything

 

[Zakillah]

I DIY mostly 50/50, sometimes 60-70 VG, very seldom higher.

 

[Poeb09]

I use anything from 70vg to 90vg in the crius v3 and the serpent rta the serpent wicks so efficiently but the crius performs almost as good And no congestion or heavy chest I've only found one juice that did that it was a diy version of castle long and wont touch it ever again

Sent from my LG-H810 using Tapatalk

 

[petrotech]

50/50...

Any higher makes my lungs get "heavy"

Plus it's easier to talk about ratios on the forum that way.

 

[Elyptic]

Most of my "tank" juices are between 50-70% VG. I save the higher VG stuff for dripping.

 

[Ronald3638]

50/50 Diy The store bought doesn't say but it seems to be about 60%-70% VG.

 

[KenD]

I'm pretty much at 50/50.

Sent from my M7_PLUS using Tapatalk

 

[PapaGeno21]

70pg/30vg

Runs great in everything.

 

[chief63]

I typically use 70vg in various RTAs (Crius, Aromamizer, Griffin, MT-RTA, subtank) at home and a Melo 2 with stock coils at work.

 

[godfatherI]

70 - 90 VG; kayfun 4, bellus, subtank.

I used to have issues with high VG in the kayfun, but started wrapping a spaced coil and installing at an angle. For some reason, that fixed any wicking issues.

 

[nelsonm64]

50/50 here. I've never understood max VG? I have always found PG to be the better flavor carrier... I guess if you react badly to PG I understand but, other than that I don't really get it.

 

[ThunderDan]

80VG+, closer to 90VG on my DIY, and around 80VG is what most of the retail juices I buy seem to be.

I don't like PG at all, it bothers me.

Assorted modern dual coil, and single coil RTAs, Mutank, VCMT, Aromamizer RDTA, Bellus, Goblin mini, Serpent, K4, etc.

 

[DaveP]

I guess I've been Vaping Dekang and Hangsen so long that I've settled into 80pg juice as a standard. I get 0 nic for $8.99/50ml and 6mg nic for $11.99/50 ml and mix them to make 3mg juice.

They are clean, clear, and lightly flavored. I lose interest with heavily flavored juices and have to change before the tank is empty. Just me, I guess. Too much flavoring gets old quick.

I have a number of highly flavored juices that I use as additives to my Dekang and Hangsen. 5% or 10% added to a tankful makes it just right when I want a different flavor.

Am I the only one who likes juice on the light side of flavoring?