Innokin SVD and Smoke RSST

[Lethal-Dose]

Hello well today I just got my 500 ss mesh and 30 gage kenthal wire. And im having issues with my mech mods
So im wondering will or can my innokin svd handle my rsst? What volts or watts do I need to run it at? And what ohm does the coil have to be?

 

[Margate69]

3.7 volt minimum coil resistance 1.8 ohms

But you may want to listen to someone with more experience with your specific RA

 

[Sthur]

The smoktech svd won't fire below 1.2 ohms, so keep builds above that.

I think I did 4 or 5 wraps of 30 gauge at 1.6 and works ok on my mod. Use a volt/ohm meter to check builds is important.

I am not fan of mesh wick, but now use cotton with 1.8 micro coil and like it much more now.

 

[Ronald3638]

I'm currently running 1.9 ohms on my RSST at 10 watts on a Vamo and I also have used this same build on my SVD with no issues on either device. I'm using a green apple at 30%PG 70%VG without any wicking issues.

I wrapped my coil on a 6-32 screw (4 wraps 32 gauge) then inserted the screw into the wick hole to attach the coil to the RSST then just unscrew the 6-32 screw. I rolled a wick to fit the coil and pulsed it to eliminate hot spots, just can't pulse too rapidly or you turn off your mod.

 

[Pimpwerx]

SVD will fire down to 1.2ohms. Not sure about the RSST, as I got an I-ATTY yesterday, as my first rba. I learned a lot about hotspots and shorts with my first coil. Fun times ahead. PEACE.