Innokin SVD no longer indicates correct coil resistance

[Pilot97]

My trusty innokin SVD now indicates the wrong resistance. A 1.8 ohm coil checked on a VV 3 indicates 4.4 ohms on the SVD. The SVD's contacts are clean. I also tried removing the battery, pressing the fire button for ten seconds and then reinstalling the battery but the SVD still indicates a resistance of 4.4 ohms for a 1.8 ohm coil. Is there anything else I should try?

Thanks,

 

[Ryuukon]

What device are you using? Is the pin recessed into the device? Could be it's barely making contact with the 510 pin of your SVD.

 

[SupplyDaddy]

The "reset" on the SVD is a myth...
What is the device you're measuring? Does the center pin of the SVD still spring back? It is possible the device is twisting slightly when you put it on the SVD..

~sent from my galaxy mega using taptalk~

 

[Pilot97]

I'm using an Aro II but have also checked the indicated resistance against a cartomizer. I checked the spring and that might have been part of the problem; however, my 1.8 ohm coil now indicates 3.4 ohms (down from 4.4 ohms.) Anything else I can try? If the SVD still indicates the wrong resistance can I continue using it voltage mode?

Thanks,