Innokin SVD weird reading!

[ronaldor]

Hi guys I´m new to the vapor world but loving every single part of it.
Something very weird happen when the SVD read the atomizer or clearomizer ohms. The reading is different depending how hard or loose I screw the atomizer ??? Is this happening to someone else?
My best regards to all vapors out there in this magic world. Ronald
PS. My first post I don´t know if i´m doing it wright if so sorry!

 

[FourWinds]

I don't have one, but I guess that is to be expected in a way. I'd check for dirt, and perhaps clean things up. When you're screwing things down tight you're most likely (don't assume that this is definitely the case, it could be that a tight screw is worse for the connection) making a better connection.

The lowest reading is going to be the 'best' one. I'd have a clean up of all the connection terminals and see if that takes away the variation. If you leave it like this, any resistance in the connections will steal away some of the voltage that should be across your coil; you will waste battery life, and not be able to reproduce the same vape at the same settings.


Oh, and welcome to the forum man. Nice to meet ya.

 

[ronaldor]

Thanks FW! Is amazing that all vapor I have meet are so helpful and generous always try to help newbies in someway.
Thanks for that boys&girls.

 

[Bunnykiller]

a snug connection ( not excessively tight tho) is a good thing to have loose connections will cause differing ohm readings... also check for crud on the telescoping threads and make sure the tank is snug fitting to the mod.