Ipro Dies After 3 Uses

[Penner]

I just got my new Ipro last week (& ordered new batteries from the Ipro website & charger too).

I used it 3 times. Tried to use it today with fully charged batteries (voltage on both = 4.19), & I only have 1 set of new batteries).

The CE2 clearomiser (2.8 ohm) is firing normal on my Provari at 4 volts, but the Ipro won't work.

The Ipro will have a bright red light, & it turns bright blue when I press the button, but the clearomiser will not fire.

I've cleaned the top out with a paper towel, altho it wasn't dirty anyway (where the Phillips screw is, altho I didn't fiddle with that screw itself, just wiped it off).

Whats going on?

 

[Bovinia]

Sounds like your CE2 isn't making contact. Do they have a center pin in the bottom? If so, try to pry it up just a tiny bit with a nail file or something similar. A lot of us use adapters just to avoid that problem.

Let us know if that helps...if it doesn't then we'll keep on trying

 

[doots]

Sounds like your CE2 isn't making contact. Do they have a center pin in the bottom? If so, try to pry it up just a tiny bit with a nail file or something similar. A lot of us use adapters just to avoid that problem.

Let us know if that helps...if it doesn't then we'll keep on trying

right on advice Bov!

 

[5cardstud]

It's a 510 huh? Bovinia is right. The center post on different cartos are just that, different. If it's turning blue I'm sure it's firing but the carto isn't making contact. Check out this video. It's a different carto but same principal. http://www.youtube.com/watch?v=HRx8eRZlXVg&feature=player_detailpage

 

[Andy Thatcher]

Could be wrong but thought that the Ipro had a screw you could raise to make contact with the post of the cardo in the middle of the 510 connector.

As said could be wrong but that was one of the many benefits that made me start looking at the Ipro and Buzz.

 

[sachavaca]

that center screw seals the topcap from getting eliquid inside mod tube. loosen it and you will get a shorted or malfuntioning pv

 

[BuzzKill]

to raise the center pin you need to add a plastic washer , it should be SNUG, and BOV is right it is the center pin not making contact, this happens all the time switching between devices .