IPV D2 announced.

[rhelton]

SSV Ti Clapton great vape
35J@380deg

What is the ohm's on that clapton? We were wondering how high you can go with titanium. I think its 1.00 as I have seen a few builds over .30 in the last couple day's.

The only thing this board is missing that my SX has is a battery voltage reading. Small price to pay I guess for the small price of the mod.

 

[Zayin101]

Just purchased my D2 yesterday... almost pulled the trigger on a 10% off discount code online for the usual $60 pricetag but called my local vape shop and discovered they had them in stock, so I decided to just pay whatever the higher price would be with taxes and whatnot.. Imagine the look on my face when she scanned it and $39.99 popped up on the screen! That is the everyday price of these babies here in OK City... crazy right? Back on track tho, I used to own a VaperShark RDNA 40 so I have experience with Ni coil builds, and I'm looking forward to TC again as the VS didn't exactly act much like a shark anymore when I fell into the ocean with it boating in Hawaii haha! So far loving this device, it has exceeded the performance of the VS in everything I've thrown at so far. So where can I get a hold of quality Titanium Wire?

 

[smacksy]

Just purchased my D2 yesterday... almost pulled the trigger on a 10% off discount code online for the usual $60 pricetag but called my local vape shop and discovered they had them in stock, so I decided to just pay whatever the higher price would be with taxes and whatnot.. Imagine the look on my face when she scanned it and $39.99 popped up on the screen! That is the everyday price of these babies here in OK City... crazy right? Back on track tho, I used to own a VaperShark RDNA 40 so I have experience with Ni coil builds, and I'm looking forward to TC again as the VS didn't exactly act much like a shark anymore when I fell into the ocean with it boating in Hawaii haha! So far loving this device, it has exceeded the performance of the VS in everything I've thrown at so far. So where can I get a hold of quality Titanium Wire?

Got my D2 for $49 online.. So yes indeed that $39 was a good buy for sure!

sent from my XT1080 via Tapatalk

 

[Scotticus93]

Yes, a cocktail straw vape can be more than sufficient for me, especially after smoking for more than 28 years. I suspect most vapers are the same way - though not as limited as I am by a PG allergy. Which high VG capable clearomizers would you consider better than a Nautilus (or Beyond Vape Silo Tank) these days, especially with TC compatible coils? Though I never have much time for rebuilding, which MTL-centric rebuildable tanks would you recommend?

Rip reccomends the crown and see people mentioning it in this thread so it will likely be my next tank. That or the triton. They both have adjustable airflow and premade tc coils. I think those would be better bets. STM I haven't bought premade nickel coils for either but I own one and it's airflow can be restricted quite a bit too. So one of those 3 might be a good choice. Sorry I don't have that much firsthand experience with them. I garuntee they will do tc better than that nautilus tho.

 

[AtmizrOpin]

Will my D2 work in space, more specifically, on the moon in a zero oxygen, zero gravity environment?

 

[Carnage9270]

Will my D2 work in space, more specifically, on the moon in a zero oxygen, zero gravity environment?

No, sorry. You'd be sucking on that thing til you passed out from no oxygen. The mod would work i guess, but the atomizer would have a problem getting vapor to you lol. The great part about it is you wouldn't have to worry about temp control anymore.

 

[AtmizrOpin]

The talking walnut told me to take some gut pics and post them before my trip to the moon.

 

[Carnage9270]

Lol, is it just me or does that 510 look horrible? Looks like they pulled it off an old rusty tanker ship.

 

[smacksy]

The talking walnut told me to take some gut pics and post them before my trip to the moon.View attachment 482241 View attachment 482243 View attachment 482244 View attachment 482245View attachment 482246

What mod is that? I hope it's not the little D2!..what caused this?? Yikes!

sent from my XT1080 via Tapatalk

 

[Carnage9270]

Of course it's the D2. There's a reason they are inexpensive
I'm sure it's still working just fine.

 

[smacksy]

Of course it's the D2. There's a reason they are inexpensive
I'm sure it's still working just fine.

I'll bet your personal mods look worse than that but still work great too, right?
LMAO!! [emoji23]

sent from my XT1080 via Tapatalk

 

[AtmizrOpin]

What mod is that? I hope it's not the little D2!..what caused this?? Yikes!

sent from my XT1080 via Tapatalk

It's the D2 for sure. This is my work mod. I do heating and plumbing, so there dust, saw dust etc inside it a little bit. Still purrs like a kitten. It's a decent solder job when you wipe the dust off.

 

[Croak]

Yes, a cocktail straw vape can be more than sufficient for me, especially after smoking for more than 28 years. I suspect most vapers are the same way - though not as limited as I am by a PG allergy. Which high VG capable clearomizers would you consider better than a Nautilus (or Beyond Vape Silo Tank) these days, especially with TC compatible coils? Though I never have much time for rebuilding, which MTL-centric rebuildable tanks would you recommend?

Triton with 1.8ohm coil is a good start, and handles high VG well.

Kayfun family and clones are solid rebuildable choices.

Sent from my Nexus 10 using Tapatalk

 

[smacksy]

It's the D2 for sure. This is my work mod. I do heating and plumbing, so there dust, saw dust etc inside it a little bit. Still purrs like a kitten. It's a decent solder job when you wipe the dust off.

Seriously though I'd really like to know what happened to fry that guy's D2..was it connected to a charger maybe?
Just got my D2 yesterday and so far I'm really liking it...

sent from my XT1080 via Tapatalk

 

[Carnage9270]

Seriously though I'd really like to know what happened to fry that guy's D2..was it connected to a charger maybe?
Just got my D2 yesterday and so far I'm really liking it...

sent from my XT1080 via Tapatalk

Huh? It's not fried, he just took pictures of the insides of his D2...

 

[smacksy]

Huh? It's not fried, he just took pictures of the insides of his D2...

Oh..wonder why he took it apart if it was working good then? I believe if it aint broke don't fix it... But that's just me I reckon, lol

sent from my XT1080 via Tapatalk

 

[Carnage9270]

Oh..wonder why he took it apart if it was working good then? I believe if it aint broke don't fix it... But that's just me I reckon, lol

sent from my XT1080 via Tapatalk

Because the talking walnut told him to...he IS going to space soon...

 

[Riblet]

What is the ohm's on that clapton? We were wondering how high you can go with titanium. I think its 1.00 as I have seen a few builds over .30 in the last couple day's.

The only thing this board is missing that my SX has is a battery voltage reading. Small price to pay I guess for the small price of the mod.

It's a .24

 

[Riblet]

Just purchased my D2 yesterday... almost pulled the trigger on a 10% off discount code online for the usual $60 pricetag but called my local vape shop and discovered they had them in stock, so I decided to just pay whatever the higher price would be with taxes and whatnot.. Imagine the look on my face when she scanned it and $39.99 popped up on the screen! That is the everyday price of these babies here in OK City... crazy right? Back on track tho, I used to own a VaperShark RDNA 40 so I have experience with Ni coil builds, and I'm looking forward to TC again as the VS didn't exactly act much like a shark anymore when I fell into the ocean with it boating in Hawaii haha! So far loving this device, it has exceeded the performance of the VS in everything I've thrown at so far. So where can I get a hold of quality Titanium Wire?

The only Ti wire to vape[emoji6]

Ti-Wire

 

[AtmizrOpin]

Oh..wonder why he took it apart if it was working good then? I believe if it aint broke don't fix it... But that's just me I reckon, lol

sent from my XT1080 via Tapatalk

It's called taking one for the team. I could care less about any warranty issues and I was told to take pictures of the insides from the talking walnut inside my closet. Now everybody gets to see the insides. Why would you assume I fried it? I said in my post she's still purrs like a zebra.