Ipv d2 with tfv4

[Ishak]

Hi all,

Ishak here. New to vaping. Quitting smoking.

Would like to ask a few questions;

1) Why is my mod stating "Low Res" when I use TF-T3 coil (0.18ohm) in my TFV4 with my ipv d2 mod?

2) what would be the ideal temp for TF-T3 (0.18ohm)?

What is the difference between power mode and Joule mode?

Hope you guys can help me with this. Thank you.

 

[speedy_r6]

1) If it is a 0.18 ohm coil, the d2 shouldn't fire it. It is a kanthal coil(temperature control not supported) and the d2 will only fire down to 0.2 ohms if it isn't in temp control mode. The minimum for the d2 to fire with a kanthal build is 0.2 ohms. Since 0.18 is lower than 0.2, it is reading "Low Res" indicating the coil resistance is too low to fire. For temperature control mode, it supports down to 0.05 ohms, but the coil needs to be made with Ni200 wire.

2) Can't really say. The TF-T3 is made of kanthal and not Ni200, meaning it isn't made to be used in temp control mode.

Power mode is what is to be used with kanthal coils and does not support temp control. Joule mode is for temp control and only works with Ni200 coils.

Based on that, it is doing exactly what it should be doing.

 

[crxess]

You can set the D2 to TC - Ni mode
Lock the coil cold - press and hold -/+ together for a few seconds

The Max you can set is 50J and you should set temp to Max(600?)

It will NOT regulate temperature with the kanthal in TC!

But it will fire