Issues with RDA

[STEELRAIN]

I am having massive Ohm fluctuation issues. I am using Kanthal wire 32ga. tried 8 loops all the way up to 13 loops. the lvls dont stay consistent at all. anywhere from 4.8ohms down to .8ohms. using organic cotton for the wick. not using a mech mod. VV/VW Volcano LT V2.5. any help would be awesome. really wanna get into dripping. and rebuilding my PT3 coils as the Kanger ones are junk.

Thx

 

[Steam Turbine]

If you are having fluctuations it means that your coil is not well ''attached'' or screwed on your atty... Thighten your screws, make sure that the actual coil is not touching any part of the atty.

 

[dripdaze]

I agree with Steam. Check for tightness of screws.

 

[Brennan4x4]

got a picture of your build? most commonly it's the screw connections like mentioned before but pictures can help.

 

[InTheShade]

If you can post up a picture that will help. If not, can you give us a little more information?

Are you wrapping a touching-wrap coil like a micro-coil? I am assuming so.
What rda are you using?

Make sure your coil is not touching anything that it shouldn't. This usually includes the deck and top cap.

 

[STEELRAIN]

Its not touching anywhere. The RDA is a cheap intro one the box didn't even have a name on it. I think ur right its the screws. It dosnt have holes for the coil so I have to attempt to wrap them around the terminals. Its not easy to get a tight connection. And yes its a micro coil.

 

[jd1978]

Sometimes my IGO-W reads like that on my vamo v5 because that perticular RDA doesn't make good contact with the mod. I don't have any problems with the IGO on either of my other two mods nor do I have problems with the vamo with any of my other rda's. Just the two together don't mix for whatever reason.