It always leave some e liquid on my hand

[Maiar]

I just wash my hands after filling up. Don't want to pet the dogs or anything with that .... on my hands anyways.

 

[disallowedword]

I don't blame you... look at this...





What the hell is going on here... "lemon juice", "rubber gloves" ? Did someone mention 100mg nic?

I've dripped 24mg, licked it off my fingers when it spilled. Many of us have.
Seen folk sploosh 60mg and not have an aneurism.

fythua was asking about changing a coil head.
Could we try to not scare the chilluns'. Or, at the least... yourselves.

HAHA, some people are funny! I been known to add a squirt or two of 18mg irish cream ejuice to my coffee occasionally.

 

[inspects]

When i replace an aspire nautilus coil, leftover e liquid always make my hand dirty, don't like the refill method which need open whole tank.

Perhaps a top-fill atty would work much better, bottom fills are old-school, no longer necessary.

 

[Two_Bears]

If getting juice on your hands was harmful, I'd be dead long since. AFAIK, there are no tanks that don't require you to open them to get at the coil, although there are some that let you take the base off without emptying the tank (so long as you hold it upside down). I'd tell you to switch to a dripper, but they'll get juice on you occasionally too.

What about the Innokin Isub? It has much less chance if getting juice on you removing the coil. The sub tank the old Clearomisers etc it is impossible to remove coils without getting juice on the hands.

But yes it rinses right off.

 

[Maiar]

What about the Innokin Isub? It has much less chance if getting juice on you removing the coil. The sub tank the old Clearomisers etc it is impossible to remove coils without getting juice on the hands.

But yes it rinses right off.

You still gotta take it apart to fill, and setting the base down is messy with that one. The quick swap coil system is nice in theory, but you hardly use it honestly. You refill way more often than change coils. Honestly as far as bottom fills go, my subtank mini is the least messy of the group as long as you set it upside down for a minute before opening so all the juice falls away from the coil.

 

[Canadian_Vaper]

I keep a cloth in my vape station aka my computer desk drawer, I use it to change coils etc so I don't get it on my hands.

 

[Falconeer]

I smoked Falcon Pipes for many years - I always kept a wad of tissue around for moping the juice out of the humidome after each bowlful - I suspect that juice had the potential to do a lot more harm than e liquid does; that said I unscrew the base with a tissue in my hand and ditto when changing the coil. I think a little liquid spill goes with vaping, dot, period, end of story.

Any juice washes off in seconds.

 

[glointhedark]

When we do takeout food, I save the extra napkins and cut them down to use when refilling or changing the coils on my Evod Glass. Paper towels can also be cut down to a reasonable size for this task. I also use qtips to clean the threads on my Evod Glass and the base when I am changing the coils.

 

[suprtrkr]

What about the Innokin Isub? It has much less chance if getting juice on you removing the coil. The sub tank the old Clearomisers etc it is impossible to remove coils without getting juice on the hands.

But yes it rinses right off.

It's a fine tank. I would cheerfully recommend the iSub G over the Subtank if it had a better coil selection.

 

[Two_Bears]

It's a fine tank. I would cheerfully recommend the iSub G over the Subtank if it had a better coil selection.

I never used the isub of isubg.

I used the Subtank. Not too impressed with the flavor tho till I started rebuilding the OCC heads.

I also know the isub coils have mesh on top to prevent spitback.

Have anything to add?

 

[suprtrkr]

Nope. I rebuild. I don't need or want a factory coil tank. But I hit one at the vape store and it's a nice tank. I just hesitate to recommend it because of the thin coil selection.

I never used the isub of isubg.

I used the Subtank. Not too impressed with the flavor tho till I started rebuilding the OCC heads.

I also know the isub coils have mesh on top to prevent spitback.

Have anything to add?

 

[Jim_ MDP]

Which has now, finally, expanded. They added Ni, Ti, SS and at least one Clapton.
And the RBA head is possibly out early, word was not until mid/late January.

 

[Two_Bears]

Nope. I rebuild. I don't need or want a factory coil tank. But I hit one at the vape store and it's a nice tank. I just hesitate to recommend it because of the thin coil selection.

I know you are rebuilder as I am.

You have handled the Isub and I haven't. I just thought you have more to share with the participants.