Itaste MVP Queston

[FringeChief68]

None of my DCT tanks will work on my MVP not even my Prive.
I tried my tanks that use 510 SMOKTECH XL 2.0ohm Dual Coils (Bottom plated), my Submarine tank that uses Boge (2.0 OHMS)
and my Prive that uses Boge (3.0 OHMS).

BUT these all work: Smoktech XL Single Coil 1.7 Carto's, 510 Standard Dripping Atomizers, CE4 Clearomizer Tank
and the iClear 30 and iClear 30s.

I tried to take beauty ring off too.

 

[Jayvaps]

tolerances.

Some manufacturers have different tolerances for the length of the center pin.

typically, on innokin products, they have a very deep 510 connection. you can try pulling down the center pin on some devices, but more likely you may want to wiggle the center pin up on the mvp, or file some of the collar off around the top of the connection so devices dont stop screwing in to quickly and stop before making a connection with your MVP's center post.

compare the collar and depth of the 510 connection on your MVP, and you will probably notice it is a bit deeper than other devices. Of course, the iclear line fits well in their devices because they typically have longer threading and a longer connection that fits well on their products.

at least that is my suggestion.

 

[Penn]

Jay is right but I would go with the center pin on the carto first. I know the carto I used on the MVP ends up with the pin recessed if I use it on an ego so I just pull it out slightly. Of course I don't even use that carto, which was converted to a dripper, since I use and RDA now.

 

[Rocketpunk]

Sometimes you can use a paper clip to kinda "tug" on the contact pin in your delivery device (carto, clearo, etc.).

I've found those tiny little screwdrivers you get for eyeglasses and such work extremely well for nudging around center pins on the battery device.

If those didn't work, I chalked it up to a DOA head/carto.

 

[DetraMental]

What they all said!

 

[FringeChief68]

Thank you everyone!!!
I used little screwdriver to pry out contact pin on Carto and it worked