Itaste mvp won't fire

[Koolbee]

This might have been asked before ... But my mvp won't fire on my kayfun or kraken anyone know why?

 

[Nick.G]

Only on those, or at all?

 

[Koolbee]

Only on those 2

 

[dannyrl]

Check your ohms by pressing both side buttons at the same time. If it says "non", the 510 isn't making contact with your MVP. If you resistance is below 1 ohm, it won't fire because the resistance is too low.

If neither of those are the case, I'm stumped lol.

 

[itskohler]

Could be a ground issue with the coils.

 

[Nick.G]

Have you taken them apart at all? I took apart A LOT of cartridges and always messed up connecting the coils to the hot and the ground posts, caused a no fire on all of them and ruined them haha

 

[Baditude]

What is the resistance of the coils?

Will the MVP measure the resistance? Or does it say "NON"?

 

[Koolbee]

Yes is says non ... Is there anyway around that

 

[Susan~S]

Sometimes my MVP says "non" if the atomizer is screwed on too tight. Check that as well.

 

[itskohler]

Adjust your center pin maybe?

 

[dannyrl]

Yes is says non ... Is there anyway around that

Perhaps one of your other tanks pushed the pin on your MVP too far down and your Kayfun and Kraken can't reach it anymore.

If you have a small flathead screw driver (like the one that came with your Kayfun), gently push on the sides all around the center pin of your MVP to try and pry it back up.

 

[Btsmokincat]

If the 510 pin has been squished down it might not be high enough to make a connection. Take a toothpick, paperclip or micro screwdriver and place it between the pin and the wall. GENTLY wiggle against it all the way around to raise the pin. This should solve your connection problem. I have to do this occasionally and it always works even if it doesn't look like the pin has moved a mm.

Whatever you do DON'T grab the pin with needle nose pliers and pull. I've heard of people popping the pin out and messing their MVP up. Also screw tanks on until they just make a good connection, unscrew the beauty ring to close the gap.

 

[Capt.shay]

The contact pin is notorious on the MVP. Reach in with a pin or little screw driver and wiggle the pin up first on one side then the other. It will work up and you will have contact again.

Go down to the MVP thread in variable voltage forum and find many fixes for this problem.

Welcome to the ranks!

 

[daviedog]

70% of my rba's won't fire on my MVP. The 510 thread seems to be a millimeter or so shorter than carto's.
A 510/510 extender does wonders. And on the rest? No loss, the MVP is boring..