Ithaka new rebuildable part
- Thread starter imeothanasis
- Start date
- th_trl_thread_readers 0
- Status
yes mit. justGG and drip mouthpiece will be ready again in about 3-4 days. This will be the last run because I already started making proteus
Thanks Imeo, I guess my new microcoils are just producing bigger clouds!
Hi Imeo, using the new dripper kit for ithaka and new rebuildable parts, do i need to place the oring on the brass post? Now i set it up without but when i put it upside down, it leaks from the mouth piece.
you put a lot of drops inside Ithaka Hs. The dripper was made to hold up to 20-25 drops
Will JGG SS be available only whether also JGG Brass will be available in the same delivery?
Will Ithaka CR Brass (New Alloy) be available also?
justGG in SS, justGG in brass and CR for Ithaka will be made or not be made at the same time Risto. I make parts and I send them to vasilis but not all together. I send him what is ready
It's funny how the delay of Proteus allowed us to have tons of spares. That's looking at the bright side I guess. I think even if imeo kept on producing parts there are always people buying them. GG is addictive something that others couldn't do in my opinion.
Thank you aal
I thought of it a lot of times and I agree that Proteus delay was good for all of us. You had almost exactly what you needed, I kept machines busy and also I had time to make Proteus even better. I reduced its length a little more and I made some small changes on venting cap, connector and button.
All are going better than scedule!
I thought of it a lot of times and I agree that Proteus delay was good for all of us. You had almost exactly what you needed, I kept machines busy and also I had time to make Proteus even better. I reduced its length a little more and I made some small changes on venting cap, connector and button.
All are going better than scedule!
Hey for those of you using the new dripper kit for Ithaka and the new rebuildable part.. got any photos of your setup? I'm wondering how much cotton to put in. I was thinking of basically having the cotton run along the inside edge of the metal cup in a circle.. that would probably be enough, right?
I didn't get the drip kit however in all my drippers I don't put too Much Cotton. Cotton takes a lot of liquid and keeps it. It is better to have liquid in the dripper that touches the cotton instead of cotton that traps the liquid.
So would my typical MrKrinkle method setup work ok with the dripper? I just envisioned it not being enough to catch my droplets.. but I've never really had a drip atty before so I can't really say
most people want to use it as a pure dripper. That means that they put liquid only on wire hsan. I prefere to use it as a semi-dripper, something like a tank-dripper
Thats what i am doing imeo. Normal dripper, i have to deal with condensation, but ithaka, since its tank dripper hybrid, i dont even have to handle this.
Sent from my iPhone using Tapatalk
- Status
Similar threads
