Ithaka simple build Video and Review

[TheToxic_jon]

hello everyone i did a video on ithaka.
tutorial on making wire and coil(a variation of bishops build)
thanks for watching, hope this helps
Device Review: GG Ithaka review and my build - YouTube

 

[Clint]

Great video! Thanks for sharing.

 

[imeothanasis]

That was a great video Toxic, thanks a lot for doing it buddy

I noticed that you putted 2 wicks inside one channel so you made the Basic Feeding screwing too hard. Did you have a reason for that?

Also, we have to pay a little attention on ohms of the wires. Too small ohms may lead to a battery overload that is not good for several reasons.

 

[TheToxic_jon]

That was a great video Toxic, thanks a lot for doing it buddy

I noticed that you putted 2 wicks inside one channel so you made the Basic Feeding screwing too hard. Did you have a reason for that?

Also, we have to pay a little attention on ohms of the wires. Too small ohms may lead to a battery overload that is not good for several reasons.

next time i do a coil i may put coils in X, but differant channel and cut center wick. I'm just experimenting at this point
this build i did in video is wicking very well, and i dont want to take it apart yet
ya i think my ohms reader is on the fritz, it has done this before. where it reads low but the atty isnt that low, then i fill with juice it goes up
thanks imeo i need all the tips i can get

 

[Bishopheals]

Hey Toxic i just saw your video, thanks for calling my name out. LOL I have to agree with Imeo's suggestion. In addition if I may I like to show you more of a tweak build that will give you even better results on Dual coils. let me know if you free and want to hookup on Skype.

 

[TheToxic_jon]

sure bishop, i may need a few days or a week, as im very busy.
i will get at you on vapetv

 

[Bishopheals]

ya Ill be on vapetv tonight in a few minutes.