13mm seems a little big, isnt it more like 8.5? It is lighter than a 510t as well
- Status
13mm seems a little big, isnt it more like 8.5? It is lighter than a 510t as well
I am guessing he means the quarter turn you make to pull off the cone and get to the atty
Eh, saw 2 measurements listed on joyetech's site and the ~8mm seemed to be pointing at the recharge/LED end so I figured it meant that part was ~8mm
What VC said
After tightening the bottom it doesn't leaking if I leaving it sitting on my table but one I lie it down it starts to slowly drip out... sigh back to the small plastic bottles
I would contact your vendor, most good vendors will replace or refund as long as you send back the defective product.
Yeah its weird the site says 8mm, but its really more like 8.5mm. I know somewhere in this thread someone measured it because they only were interested if it was 8mm on the notch because that was the standard analog size. Honestly i cant tell the difference, but i havent seen an analog in 4 months either
That is what I thought, too, so when I got my kit I got 5 extra cartridges, and a little case to hold them. So I start my day, with 7 filled cartridges, or 3.5ml approx, and it lasts me all day. At night I may switch to an eGo or X2 if I need more. Rinse and repeat each day. I use a syringe to fill my cartridges, and it probably only takes me a few minutes to fill the 7 cartridges.
For those discouraging the eRoll, I highly suggest you check one out. You will be surprised at just how much different (and IMO better) it is than a standard 510 or 808.
In my experience with the eGo atty heads, if you have leaks, either the atty head is flooded, or the tank seal is leaking
If the head is flooded, just take the tank off and "stovepipe" it by drawing off of the atty housing(suck on the end the tank goes into). Don't know how well it will work with the eRoll, but it works well with the eGo-C tank
If the tank or tank seal is leaking, I'd probably just replace the tank and try to find out if there's silicone caps for the eRoll tanks(helps a lot)
I believe I mentioned it earlier, but how you store the eRoll can affect whether or not flooding happens.
Basically, store with the mouthpiece pointing down(aka charger/LED end facing up).
Doing such prevents juice from leeching into the atty head, which eventually builds up into a full leak
Also, the atty heads can wear to the point that they don't seal properly, which can cause leaks as well. So even if you can keep the coil clean for 2 weeks, the silicone seals might be worn out
If the head is flooded, just take the tank off and "stovepipe" it by drawing off of the atty housing(suck on the end the tank goes into). Don't know how well it will work with the eRoll, but it works well with the eGo-C tank
If the tank or tank seal is leaking, I'd probably just replace the tank and try to find out if there's silicone caps for the eRoll tanks(helps a lot)
I believe I mentioned it earlier, but how you store the eRoll can affect whether or not flooding happens.
Basically, store with the mouthpiece pointing down(aka charger/LED end facing up).
Doing such prevents juice from leeching into the atty head, which eventually builds up into a full leak
Also, the atty heads can wear to the point that they don't seal properly, which can cause leaks as well. So even if you can keep the coil clean for 2 weeks, the silicone seals might be worn out
93mm x 8.5mm 10.8 grams.
Same diameter and slightly shorter than an analog 100 & weighs slightly less than 5 dimes.
(a shortie 808 with carto is 151mm x 9.5mm 17.4g... and i can't believe the difference that 1mm in dia makes in the feel!)
Technically, since it comes with everything you need to start vaping (except the juice) it is a 'Starter Kit', I wouldn't even call it glorified, just the best. But it has me back on the wagon, something my ProVari could not do, so it is a big WIN!
Last edited:
Sounds pretty damn good then,so the eroll is not a starter kit,sorry again,what ever keeps us off toxic poison tobacco is the main thing.
No, its a starter kit. I mean its something a new vaper could buy, and have everything you need to dive head on into the world of not smoking. Im just having fun with you because of how you put it. If definitely works for a lot of people, which is nice because there was a lot of disgust with the product pre release!
Ha ha ha. My ucan never did that. And I throw it all over the place. It's 1:00 pm here and I just finished my 8 eRoll tanks. I use a variety but my best favorite juice is in the eRoll tanks so I keep going back to it. Reason I put my good stuff in it is because it tastes better! However I do get fed up with the loooong sloooow draw I use to get that best flavor and overall I end up vaping less with eRoll but not today. Gonna fill the tanks back up and keep on keeping on. (. :
I guess the expression 'glorified" was not a good choice of terminology,actually,i think this little cute kit is the ideal way too get older folks on the band wagon to health,i was actually thinking of sending one to my mother for her birthday,she 75 and smokes like a chimney.
http://www.youtube.com/watch?v=H4NalzEiNyg
Last edited:
The only thing i can say is if you have no experience with the device, and are giving it as a gift to an unexperienced vaper; When changing tanks clean out the cone area of condensation. My tanks usually covered in condensation too, i have to cover the eliquid reservoir and blow through it to get it out. I rinse the carts on occasion and shake dry as well.
Other than the battle with condensation as a bottom boil device with a vapor chamber, its very hassle free.
She will be ok,she had one before but it was a no name brand,i was gonna get her the egoc,but i think the eroll is perfect,ill send extra atty heads and an extra cone,i believe the kit only comes with one cone.
I can say that me and my wife have been using our eRolls for a couple days now and we both love them. This is our first vaping device and it really produces awesome vapor and good flavor. Its size and pcc combined with a blunt needle tipped juice bottle make it a completely awesome portable system. I may get something bigger for home in the future...but for now this thing is pretty impressive! I don't think tank leaking is really an issue if it is handled properly (condensation is the only thing we have seen so far). I did take the time to learn how to rebuild the atty heads to save money (either with a mesh wick or imist wicks). Hopefully, we can vape for a long time with these devices without major problems (knock on wood).
- Status
Similar threads
